Catalogs >
iWave Systems Technologies Pvt. Ltd. >
GPS Module with Active Antenna

GPS Module with Active Antenna
2Pages

Catalog excerpts

Embedding Intelligence IWave GPS Module delivers high sensitivity and accuracy with low power consumption. Based on SiRF Starlll chipset, it has the ability to capture weak satellite signals even in urban settings, canyon and thick foliage. 20 channel GPS receiver enables fast acquisition and reacquisition. GPS module design is flexible to accommodate various RF interference scenarios. Fine components and in-house design expertise offer superior quality and support. Small form factor helps you to create cutting edge compact devices for Personal Navigation, fleet management, asset tracking, personal tracking, surveying, security and other navigation devices. Chipset: SiRF Starlll GSC3f/LPx Channels: 20 channel receiver, L1 Frequency ♦ Cold Start: < 41 sec average Dynamic Condition ♦ Velocity: 514 meter/sec maximum Protocol: NMEA Output Protocol message: GGA, GSA, GSV, RMC, GLL, VTG Antenna Interface: SMA connector or U.FL Connector* Operating/Storage temperature: -25 deg. C to +80 deg.C/ -25 deg. C to +85 deg.C IO connector (6 Pin): UART Interface, 3.3V Power Input, Back-up battery power Input(optional) ♦ Width (With IO Connector): 24.24mm +/- 0.2mm(24.8mm +/- 0.2mm) ♦ Height (With SMA Connector): 8.35mm +/- 0.2mm (14.9mm +/- 0.2mm) * Contact /wave Marketing for more information ** For More information on Mechanical details or any other aspect please contact /wave Marketing /Wave Systems Technologies is an embedded Hardware and Software Turnkey Design Services company, focused on providing integrated solutions for developing innovative products and systems in the areas of Communication, Consumer electronics and Multimedia. iWave offers complete turnkey solutions for systems engineering and product development.

Open the catalog to page 1

Embedding Intelligence Mounting Hole- iWave GPS module IO Connector The pin details are provided in the table given below. Antenna interface details to iWave GPS module Only Active Antenna support is provided, 2.85V is provided to Antenna connector. Gain of the Antenna recommended is approximately 28 +/- 2 dB. SMA connector is used to interface external Active antenna to iWave GPS Module. Option to connect Active Patch Antenna is provided through U.FL connector Test jig setup with RS232 or RS485 or USB is available for the above module. Customer can evaluate iWave GPS Module using these...

Open the catalog to page 2

GPS Module with Active Antenna 2Pages

Catalog excerpts

All IWave Systems Technologies Pvt. Ltd. catalogs and technical brochures

GPS Module with Active Antenna
2Pages