Catalogs >
ITW Switches >
Spectra edge

Spectra edge
1Pages

Catalog excerpts

SpectraEDGE SDES, SDEC ranges This is the switch for through panel mounting, where the user is expected to set the codes, or in live card access applications. Principal Electrical and Performance Data at 20°C 70% R.H. Contact Ratings: Non Switching: 100Vac, 5A Switching: 1µV to 100V, 1µA to 1A up to 10VA. Fully enclosed SDES series is on 0.300 mounting centres. Allows for through panel mounting from the edge of the PCB 1µm hard gold plated wiping contact gives high reliability in low level circuits. Base and tape sealed for flow soldering and solvent/aqueous washing. If you have a volume requirement for a product variant not shown on this sheet, please contact us. SpectraEDGE ON/OFF s.p.s.t. Number of s.p.d.t. Part Nos SDES-plus suffix Soldering: solderability: < 2 seconds to wet at 235°C as per IEC 68 and BS 2011 Test T, solder bath method. Resistance to soldering heat as per IEC 68 and BS 2011 10 seconds satisfactory at 260°C when mounted on 1.5mm PCB. Please note: BS 2011 is now superseded by BS EN 60068. Humidity: BS 2011 Test Ca: 56 days. SpectraEDGE ON/OFF d.p.s.t. Part Nos SDES-plus suffix Life: For the first 1000 closures the standard deviation of thechange in resistance from the mean is usually less than 1m . Mechanical wear out of the sliding actuator is usually observed after 10,000 operations. Capacitance Between Open Contacts: < 1pf at 1KHz. Temperature: Operating range for continuous electrical use and manual operation is restricted to -55°C to +100°C for standard products. Dielectric Strength: 1 minute: 500Vrms 50Hz. Initial Contact Resistance: (at 10mV, 10mA max.) Typical: 10m . Max. 20m . SpectraEDGE GANGEOVER s.p.d.t. SDEC 013 & 023 series Number of s.p.d.t. Part Nos SDEC-plus suffix

Open the catalog to page 1