The Next Level of Technology TPC-9 Time-Based Pattern Controller The TPC-9 Pattern Controller from ITW Dynatec, used in conjunction with your hot melt adhesive applicator, accurately controls glue output for reduced waste and more consistent output. Users can program a custom pat- tern with up to two glue events or simply choose the economy mode feature that automatically creates a skip of 30 or 50%. Both utilize adhesive more efficiently while still ensuring a strong bond, and the TPC-9 also gives you the flexibility to store up to 9 programs of different settings. TPC-9 Time-Based Pattern Controller • Test mode available for maintenance and/or troubleshooting. • Simplified "economy" mode feature for skip patterns that reduce adhesive consumption. Provides accurate adhesive output for consistent quality. Store up to nine different multiple sized products. Economy mode setting for simplified "skip" patterns. TAP TWSfFT BUTTON TO ENTER "EVENT TIMING" MODE EVENT TIHINGT>*CajSTED WHILE THIS INDICATOR IS LIT THE LEFT BUTTON STffSsyROUGH DELAY, GLUE1, SKIP & GLUE2 THE RIGHT BUTTON INCREASE^SUNT, FROM 0001 TO 9999 SEC THE CENTER BUTTON DECREASES THPTIMING FOR EACH FUNCTION ALL CHANGES ARE MADE "ON THE FLY" AND ARE BACKED UP IN THE APPROPRIATE PROGRAM MEMORY AFTER STEPPING PAST GLUE 2 PRESS AND HOLD THE LEFT BUTTON TO ENTER "PROGRAM" MODE THE RIGHT BUTTON SELECTS HIGHER NUMBERED PROGRAMS 11-91 T"" CENTER BUTTON SELECTS LOWER NUMBERED PROGRAMS 11-91 ■~ THE LEFT BUTTON TO RUN THE SELECTED PROGRAM PRESS THE CENitBBJTTON IN RUN MODE TO TEST/PURGE VALVE PRESS RIGHT BUTTOlSajOGGLE ECONO/STITCH MODE ON AND OFF ITW Dynatec - TPC-9 Pattern Controller Switch to Stitch and Save Replace a 6" continuous adhesive bead with a 6" skip pattern, and you cut adhesive consumption by up to 50%. It's simple, and the savings are certain. The TPC-9 also goes the extra mile with a built-in algorithm that always ends an event with glue when using a stitch pattern so the edge is never "skipped". Make the switch today and see

TPC-9 Time-Based Pattern Controller Specifications Operating Temperature Storage Temperature Number of Events per Program Output Voltage Outout Wattage Number of Triggers Trigger Power Supply Trigger Input Signal NPN/PNP or contact closure NPN/PNP or contact closure 9.999 seconds per event (1 millisecond increments) 9.999 seconds per event (1 millisecond increments) Power Supply Input Wattage 60 watts (without output load) 60 watts (without output load) Related Products • • • • • Melters Feed Systems Hoses Applicators Nozzles SEE REVERSE FOR ELECTRICAL HOOK-UP 3/2012 ITW Dynatec ITW Dynatec reserves...