Catalogs >
ITW Dynatec >
BF Mod-Plus Marathon- Adhesive Applicator

BF Mod-Plus Marathon- Adhesive Applicator
2Pages

Catalog excerpts

BF Mod-Plus Marathon- Adhesive Applicator - 1

The Next Level of Technology BF Mod-Plus Marathon™ - Adhesive Applicator The BF MOD-PLUS MARATHON™ adhesive applicator is an air-operated, single or multi-orifice hot melt adhesive applicator assembly with an integrated filter cartridge which prevents particulate matter from obstructing flow through the nozzle orifice. The Marathon’s™ screw-on nozzle seat allows for fast and easy nozzle change, and the optional stroke adjustment allows for fine-tuning of optimum adhesive cut-off at the nozzle tip. BF Mod-Plus Marathon™ Applicator: • Standard air open/air close module provides positive shut-off and on-cycle • Platinum sensor provides better temperature control over nickel sensors • Compatible with most competitive configurations • Water resistant optional • Built-in, heated filter has the largest surface area on the market, resulting in longer filter life and less nozzle clogging Reliability Air open/air close standard gives clean, sharp cut-off every time. Performance Built-in, heated filter better maintains a clean nozzle orifice. Simplicity Easy-to-remove module body saves time during module changes. ITW Dynatec - BF Mod-Plus Marathon™ Applicator shown with optional EZ-Change™ nozzle The Dynatec Difference... Air open/air close standard Over time, adhesive applicator modules that use an air open/ spring close system can lose spring tension, resulting in stringing and poor cut-offs. The BF Mod-Plus Marathon™ applicator module is designed to operate as an air open/air close system that does not rely on a spring to close the orifice during operation. The result is both cleaner cut-off and better operation over a longer operating lifespan. While this feature may be optional on competitive modules, only ITW Dynatec offers this feature standard on the BF Mod-Plus Marathon™ adhesive applicator.

Open the catalog to page 1

BF Mod-Plus Marathon- Adhesive Applicator - 2

BF Mod-Plus Marathon™ - Adhesive Applicator System BF Mod-Plus Marathon™ Operating Temperature Range More Filter - Less Clogging 38°C to 218°C (100°F to 425°F) Minimum Operating Pneumatic Pressure Maximum Operating Pneumatic Pressure • Over 6x the surface area of competitive standard filters. • Longer life & less nozzle clogging over competitive standard filters. • Built-in filter is heated for better adhesive temperature control. • Built-in filter purge valve for easy back flushing further increases filter life and reduces nozzle clogging issues. 5 bar (74 psi) 9.7 bar (140 psi) Minimum...

Open the catalog to page 2