TECHNICAL DESCRIPTION

The iTS splash water chambers from the SWK series enable standard-compliant tests in accordance with the following test standards (always without the addition of NaCl). The tests simulate conditions that can occur during vehicle operation, particularly in the rain or when driving through puddles. Standards and regulations The test standard for the splash water test specifies the following general conditions for the SWK: SWK • Note: Admixtures of NaCl in the splash water are not permissible.

The SWK splash water chamber can be easily positioned in the test room using the castors. After connection to the supply and operating media, standard-compliant and self-defined test runs can be started in the SWK. Splash Water Chamber

STANDARD SCOPE OF DELIVERY – SWK SERIES Functional description of splash water nozzles Splash water nozzles Splash nozzle according to ISO 16750-4 2-component milled part consisting of material no. 1.4301 Norm distance between the nozzle and DUT [mm] Splash width (at norm distance) [mm] Water amount per splash [l] (at a splash duration of 3 sec) Number of splash nozzles for simultaneous use 325 +/-25 450 3 to 4 2 (fixed and flexible nozzles (optional) can be freely combined) 4 (for SWK 200-150-100) Splash water nozzle installed in the right side wall (installation of a 2nd nozzle possible)

GENERAL REQUIREMENTS ON SITE - SWK SERIES Waste water connection • Note: The waste water connection also serves as overfill protection for the tanks of the splash water system and must be present.

OVERVIEW: OPTIONS - SWK SERIES The individual options are described below.

We reserve the right to make design and technical changes in the interests of further technical development. This applies to the entire technical description. INNOVATIVE TEST & MEASUREMENT SYSTEMS IndustriestraBe 18 47589 Uedem / Germany Internet: www.its-gmbh.de/ Email: [email protected]