FORCE MEASUREMENT OF A FLAT SPRAY NOZZLE ACCORDING TO DIN EN 60529 / ISO 20653

Product catalog summary

Standards and Regulations
The document outlines the standards relevant to the IP X9 / IP X9K tests for flat spray nozzles, focusing on the jet force distribution of the water jet. The key standards include DIN EN 60529 and ISO 20653, both of which mandate force measurement with a protocol. LV 124 refers to these standards for force measurement.

Nozzle Measurement Procedure
Each flat spray nozzle is individually registered and measured on a calibrated test system. The process ensures traceability of the nozzle's standard-compliant design through numbering and associated protocols.

Measurement Process
The nozzle is installed in a test system and operated under specified parameters. A sensor on a movable carriage records the force distribution of the water jet, which is documented in the test report as a diagram.

Note
The document is subject to design and technical changes for development purposes.

Contact Information
iTS GmbH, Industriestraße 18, 47589 Uedem, Germany. Website: www.its-gmbh.de, Email: [email protected], Tel: +49 2825 - 30798-0, Fax: +49 2825 - 30798-20.

Version
Rev 00, approved on 02.03.2026 by CM.

Catalog excerpts

FORCE MEASUREMENT OF A FLAT SPRAY NOZZLE ACCORDING TO DIN EN 60529 / ISO 20653-1

TECHNICAL DESCRIPTION FORCE MEASUREMENT OF A FLAT SPRAY NOZZLE ACCORDING TO DIN EN 60529 / ISO 20653

Open the catalog to page 1

FORCE MEASUREMENT OF A FLAT SPRAY NOZZLE ACCORDING TO DIN EN 60529 / ISO 20653-2

INNOVATIVE TEST & STANDARDS AND REGULATIONS The most important standards which refer to the IP X9 / IP X9K tests with a flat spray nozzle, in addition to the nozzle geometry, specify a verification of the jet force distribution of the water jet. With a measured and approved nozzle, a standard-compliant test can then be reliably carried out in an iTS test system. Force measurement - nozzle

Open the catalog to page 2

FORCE MEASUREMENT OF A FLAT SPRAY NOZZLE ACCORDING TO DIN EN 60529 / ISO 20653-3

INNOVATIVE TEST & NOZZLE MEASUREMENT PROCEDURE The flat spray nozzle is installed in the test system and operated with specified test parameters. A sensor installed in a movable carriage is moved under the water jet so that the force distribution can be recorded. This force measurement is listed in the test report in the form of a diagram, among other things. Force measurement - nozzle

Open the catalog to page 3

FORCE MEASUREMENT OF A FLAT SPRAY NOZZLE ACCORDING TO DIN EN 60529 / ISO 20653-4

INNOVATIVE TEST &MEASUREMENTSYSTEMS NOTE Subject to design and technical changes in the interests of technical development. This applies to the entire technical description. INNOVATIVE TEST & MEASUREMENT SYSTEMS IndustriestraBe 18 47589 Uedem / Germany Website: www.its-gmbh.de/ Email: [email protected] Force measurement - nozzle

Open the catalog to page 4