video corpo

PM605XE
4Pages

{{requestButtons}}

Catalog excerpts

PM605XE - 1

PM605XE Integrated Circuit board The brushless motorized roller PM605XE has the circuit board and gearmotor integrated within the roller allowing a good tightness, easy wiring with M8-5pins connector and space saving. It can be easily controlled by: PLC, Asi-Bus via Bihl & Wiedemann module, or logic sensors with integrated ZPA from Wenglor, etc. It is designed for conveyor lines of light and medium loads (up to 500Kg max), in order preparation, in distribution, and for assembly lines. The motorized roller PM605XE is the ideal solution to answer to the difficulties coming from the working environment (liquid, dust, …).

Open the catalog to page 1
PM605XE - 2

Advantages Compact and waterproof All is integrated in the roller and the cable is equipped with a M8 connector insuring a maximum tightness (IP65). Starting current limited to 2A in order to optimize the 24VDC power supply. The dynamic braking is guaranteed without any risk of energy return generated during motor stopping. Ecology and safety No noise or oil rejection. Everything works with very low voltage, without compressed air. Quick and easy installation Ease of installation on the conveying systems thanks to a practical and quick wiring. Integrated protection Motor and circuit board...

Open the catalog to page 2
PM605XE - 3

Electro-mechanical characteristics Characteristics Motor Absorbed power (W) start-up nominal Continuous or intermittent 1440 starts/h max. Minimum duty cycle : 1s ON / 1,5s OFF Dynamic braking Nominal speed (m/min) 300 - 1500 mm = 160-70Kg per roller Start / Stop, Direction of rotation Input signal 10 speeds with speed adaptor (ext. resistance) Speed setting 10 speeds by external analog voltage of 0-10VDC Against polarity reversal 0/24V and power backfeed, fuse, integrated thermal protection Protection index (motor roller) Direct current and brushless 24 VDC Natural rubber / nitrile

Open the catalog to page 3
PM605XE - 4

Wiring PLC PLC WITHOUTadaptator ADAPTOR without Start / stop Direction of rotation Speed variation Speed adaptor Start / stop Direction of rotation Applications STOP PLC PLC WITHadaptator ADAPTOR with Zero pressure accumulation (ZPA) Belt conveyor Acceleration / Deceleration Floor conveyor Lift table References ORDER PREPARATION ITOH DENKI EUROPE S.A.S. 490, Avenue des Jourdies - P.A.E. les Jourdies 74800 St-Pierre-en-Faucigny - France Tel : +33 (0)4 50 03 09 99 - E-mail : info@itoh-denki.com

Open the catalog to page 4

All ITOH DENKI EUROPE catalogs and technical brochures

  1. PM500XE

    4 Pages

  2. POP-UP

    4 Pages

  3. M-RAT

    4 Pages

  4. F-RAT-NX75

    3 Pages