Pickling for brazing BrazeTec EX td en ex rev.2Composition and technical data: Composition (% in weight) Applications It is used to remove flux residues from steel parts Operating conditions During pickling use containers which are resistant to acid and temperatures up to 90 ° C such as rubber-coated steels, Cr-Ni-Mo steels and polypropylene. If heating system is chosen, use Cr-Ni-Mo steels containers. Notes For pickling process: mix product in water, ratio 1:6. Use a maximum temperature of 60°C for 3-10 minutes. For washing and passivation use 1% Flux-Ex solution in water. The information reported in this document about our products and equipment as well as our systems and procedures are based on our research and our experience in the field of applied engineering and are merely recommendations. Italbras S.p.A. cannot foresee all circumstances in which these information and our products will be used, therefore the user must verify the suitability of our products and processes for the use or application intended by him on his own responsibility. Italbras S.p.A. declines any liability for any loss, damage or injury howsoever arising (including any claim brought by third parties) as a result of the use of such information. Each warranty of suitability of our products and their use within the production processes of the user, must be agreed in written form. We reserve the right to make technical modifications to this document in the course of our product development. Italbras S.p.A. part of Umicore -Strada del Balsego, 6 - 36100 Vicenza (I) [email protected] - www.italbras.it -Tel. +39 0444.3475-00 / Fax +39 0444.3475-01