TECHNICAL DATASHEET Brazing alloy BrazeTec 4404 TD EN 4404 REV. 3 Composition (% in weight) Applications Air conditioning, refrigeration and electrical industry, plumbing technology, automotive, spectacle frames (optics), precision metal parts, fashion accessories, tool industry Operating conditions Silver based brazing alloy with excellent flow, capillarity and mechanical strength characteristics. Used for brazing any steels, copper and copper alloys, as well as nickel and nickel alloys. Recommended fluxes N1/T, Super 1, N2/E, H paste, H sprayable, RS/A, FN/E, D 98, H spezial, H 280, H 80, H 285 Heat sources Induction heating, flame, furnace in vacuum and under protective atmosphere Delivery forms Wire, rods, ribbon, rings, preforms, powder Notes Brazetec 4404 is approved and registered by DVGW, as meets the requirements of the working sheet "GW2" and "GW 7" of DVGW (German Association of Gas and Water). The information reported in this document about our products and equipment as well as our systems and procedures are based on our research and our experience in the field of applied engineering and are merely recommendations. Italbras S.p.A. cannot foresee all circumstances in which these information and our products will be used, therefore the user must verify the suitability of our products and processes for the use or application intended by him on his own responsibility. Italbras S.p.A. declines any liability for any loss, damage or injury howsoever arising (including any claim brought by third parties) as a result of the use of such information. Each warranty of suitability of our products and their use within the production processes of the user, must be agreed in written form. We reserve the right to make technical modifications to this document in the course of our product development. Italbras S.p.A. part of Umicore -Strada del Balsego, 6 - 36100 Vicenza (I) [email protected] - www.italbras.it -Tel. +39 0444.3475-00 / Fax +39 0444.3475-01