Catalogs >
ISOIL Industria Spa >
LiBRA accredited calibration laboratory UNI EN ISO/IEC 17025

LiBRA accredited calibration laboratory UNI EN ISO/IEC 17025
4Pages

Catalog excerpts

LiBRA accredited calibration laboratory UNI EN ISO/IEC 17025 - 1

Accredited Calibration Laboratory Conforming to standard UNI EN ISO/IEC 17025 LAT N° 237 Signatory of EA, IAF and ILAC Mutual Recognition Agreements Calibration service for liquid flow meters Calibration Laboratory

Open the catalog to page 1

LiBRA accredited calibration laboratory UNI EN ISO/IEC 17025 - 2

The calibration laboratory consists of plants and devices for the calibration of measuring instruments for the following physical quantities: • Volume (totalized) • Volume flow • Mass (totalized) • Mass flow 8 CALIBRATION LINES The system consists of eight lines, each calibration line is designed for the hydraulic connection of a group of nominal diameters as indicated in the following table. Indirect method for static weighing The system consists of a calibration system using the static weighing method complying with the norm UNI EN 24185:1994 “Measurement of fluid flow in closed conduits...

Open the catalog to page 2

LiBRA accredited calibration laboratory UNI EN ISO/IEC 17025 - 3

www.libra-lat237.com The 8 calibration lines use different calibration methods; static weighing, direct comparison with Master Meter or with a sample volume as shown in the table: The calibration lines from 1 to 6 are equipped with submersed power pumps regulated by an inverter (the pumps are installed in a common tank with a capacity of 600 m3), a system of steel pipelines making the hydraulic path, valves, devices for air venting, process connections for the devices under test to be calibrated and an electronic scale with storage tank of adequate measurement volume capacity. A...

Open the catalog to page 3

LiBRA accredited calibration laboratory UNI EN ISO/IEC 17025 - 4

THE SOFTWARE Calibration processes activities are completely automated and directly interface with system management software that controls all calibration operations. Synoptic of lines 1 to 6 for diameters from DN3 to DN300 Synoptic of line 7 for diameters from DN300 to DN700 Synoptic of line 8 for diameters up to DN3000 THE MANUFACTURER RESERVES THE RIGHT TO CHANGE THE CONTENTS WITHOUT PRIOR NOTICE The management of all calibration orders is fully automated and is directly linked with the software system issuing Certificates of Calibration at the end of the tests. ISOIL INDUSTRIA SpA Tel....

Open the catalog to page 4