Catalogs >
ISOIL Industria Spa >
LiBRA: ACCREDITED Calibration laboratory conforming to standard UNI EN ISO/IEC 17025

LiBRA: ACCREDITED Calibration laboratory conforming to standard UNI EN ISO/IEC 17025
4Pages

Catalog excerpts

LiBRA: ACCREDITED Calibration laboratory conforming to standard UNI EN ISO/IEC 17025 - 1

ACCREDITED CALIBRATION LABORATORY CONFORMING TO STANDARD UNI EN ISO/IEC 17025 LAT N° 237 Signatory of EA, IAF and ILAC Mutual Recognition Agreements Calibration service for liquid flow meters Calibration Laboratory

Open the catalog to page 1

LiBRA: ACCREDITED Calibration laboratory conforming to standard UNI EN ISO/IEC 17025 - 2

TECHNOLOGY AND EXPERIENCE AT THE SERVICE OF THE CUSTOMER The calibration laboratory consists of plants and devices for the calibration of measuring instruments for the following physical quantities: • Volume (totalized) • Volume flow • Mass (totalized) • Mass flow 8 CALIBRATION LINES The system consists of eight lines, each calibration line is designed for the hydraulic connection of a group of nominal diameters as indicated in the following table. CALIBRATION LINES NOMINALS DIAMETERS The plant consists of 8 calibration lines running on static weight based, direct comparison with a Master...

Open the catalog to page 2

LiBRA: ACCREDITED Calibration laboratory conforming to standard UNI EN ISO/IEC 17025 - 3

The flow rates ranges and test volumes per calibration line is as follows (nominal values): PARAMETER MINIMUM FLOW MAXIMUM FLOW CALIBRATION LINE SERVICES Calibration certificates Issue of Calibration Certificates (CT) according to UNI EN ISO 17025. Calibration certificates with specific declaration of conformity * Issue of Calibration Certificates (CT) according to UNI EN ISO 17025 complete with declaration of conformity to specification with limits and decision rule defined with the customer. Legal metrological verification Subsequent verification of measuring instruments used for legal...

Open the catalog to page 3

LiBRA: ACCREDITED Calibration laboratory conforming to standard UNI EN ISO/IEC 17025 - 4

SOFTWARE Calibration processes activities are completely automated. The system management software controls all the calibration operations. Synoptic of lines 1 to 6 for diameters from DN3 to DN300 Synoptic of line 7 for diameters from DN300 to DN700 Synoptic of line 8 for diameters up to DN3000 The management The management of all calibration orders is fully automated and is directly linked with the software system issuing Certificates of Calibration at the end of the tests. THE MANUFACTURER RESERVES THE RIGHT TO CHANGE THE CONTENTS WITHOUT PRIOR NOTICE LAT N° 237 Signatory of EA, IAF and...

Open the catalog to page 4