PRESSURE LOSS CALCULATION (CONES 8° ANGLES) 9

TECHNICAL DATA OVERALL FEATURES

DIN/SMS FITTINGS

CLAMP FITTINGS CLAMP ISO 2852

INSTALLATION RECOMMENDATIONS

ISOMAG * For the correct operation of the meter the sensor and liquid must be equipotential. ALWAYS connect sensor and converter to the ground. □ It is recommended to install the connection cables away from, or protect against sources of electromagnetic noise. □ The minimum conductivity of the liquid medium to ensure correct functionality of the empty pipe detection is 20 pS/cm.

p = Fluid density [kg/m3] typical value p = 1000[AgVm3] D = pipe diameter (greater than sensor diameter) [m] u = Mean flow velocity in sensor diameter [m/s] □ Inner diameter of sensor is used for d, express in meters. □ Indeed pressure loss equation is dimensionally correct in [Pa]. The equation results in table are show in [mbar].

HOWTO ORDER CODE Complete code (*): Use suitable gasket for cleaning in place (CIP) applications (**): With this option the process connection is only suitable for cleaning out of place (COP) (***): Not available with 3-A marking

Due to the constant technical development and improvements of its products, the manufacturer reserves the right to make changes and/or modify the information contained in this document without notice. Information contained herein is not binding.

If you want to find the complete list of our distributors access at the following link: http://www.isoi! .com/en Due to the constant technical development and improvement of its products, the manufacturer reserves the right to make changes and/or modify the information contained in this document without notice. The solutions that count