GMH - Selfholding Solenoid

1 / 2 PagesView full catalog

GMH - Selfholding Solenoid

Product catalog summary

Specifications

Electrical Power: 55W for pull, 3.78W for neutralization.
Pull Force: 20N.
Permanent Holding Force (Currentless): 35N.
Rated Voltage: 24VDC.
Duty Cycle: 10% with a cycle time of 30 seconds.
Insulation Class: Class B (130°C) according to DIN VDE 0580.
Test Voltage and Surge Category: EN 60664-1, Category III.
Degree of Protection: IP00 (IEC 60529).
Electrical Termination: 2.8 x 0.8 Tabs DIN 46342-1.
Surface Treatment: Solenoid housing is zinc plated and trivalent chrome passivated; plunger is chemical nickel plated.
Weight: Plunger weight is 0.046kg; total solenoid weight is 0.245kg.

Procedures and Notes

Solenoids are manufactured and tested according to DIN VDE 0580.
Force measurements are taken at 20°C ambient temperature with 90% of rated voltage in a horizontal position.
To activate the solenoid, connect the positive pole of the supply to the plus pole of the coil (+).
Neutralization is achieved by an electrical impulse, connecting the positive pole of the supply to the negative pole of the coil (-). Note: This results in reduced power.
Force values are for reference only and may vary by ±10% due to natural dispersion.
Remanence is approximately 10% of the permanent holding force.
Special designs are available upon request.
Specifications are subject to change without notice.
The product is RoHS compliant.
Refer to "Technical Explanations" for information on solenoid use, installation, and safety instructions.

Ordering Specification

Type: GMH - Selfholding solenoid.
Size: 26.06.
Rated Stroke: Specified in mm.
Duty Cycle: Specified in %.
Termination: U for Universal.
Voltage: Specified in Volts.

Catalog excerpts

GMH-26.06 Selbsthaltemagnet GMH-26.06 Selfholding solenoid Magnet bestromt gezeichnet Solenoid illustrated in energised position Max. depth of thread for fixing screw = 3 mm Spezifikationen Elektrische Leistung ISLIKER MAGNETE AG | CH-8450 Andelfingen | +41 52 305 25 25 | [email protected] CHE-108.813.409 MWST

Open the catalog to page 1

Ordering specification GMH - 26.06 - 10 U - 24 Type GMH: Selfholding solenoid Size Rated stroke of solenoid in mm Duty cycle in % U: Universal termination Voltage Bemerkungen Notes 1) Magnete hergestellt und gepruft nach DIN VDE 0580 2) Magnetkraft betriebswarm gemessen bei 20°C Umgebungstemperatur, waagrechter Bewegungsrichtung mit 90% Nennspannung Plus-Pol des Netzes auf Plus-Pol der Spule (+) 4) Neutralisieren mittels elektrischen Impuls Plus-Pol des Netzes auf Minus-Pol der Spule (-) Achtung: Reduzierte Leistung 5) Die Magnethaftkraftwerte gelten nur als Referenzwerte und konnen infolge Toleranzen...

Open the catalog to page 2

GMH - Selfholding Solenoid

GMH - Selfholding Solenoid

Catalog excerpts

All ISLIKER MAGNETE AG catalogs and technical brochures