CUT-GRIP
7Pages

{{requestButtons}}

Catalog excerpts

CUT-GRIP - 1

New Product Announcement GROOVE TURN GIMT – Grooving and Turning Inserts with a New Advanced Chipformer

Open the catalog to page 1
CUT-GRIP - 2

New Product Announcement GROOVE TURN Highlights • New GIMT Groove-Turn chipformer for cut-grip pressed insert • Optimized for 4 applications: Grooving, Partial Grooving, Turning and Finish Turning • Standard widths 3, 4,5 & 6 mm Groove-Turn inserts are used in four different applications: Full Width Grooving Partial (finish) Grooving Finish Turning Most of the chipformers available in the market perform well in one or two of the above-mentioned four applications, but very rarely in all of them. Based on ISCAR’s accumulated experience and intensive R&D, a unique GIMT insert with a new...

Open the catalog to page 2
CUT-GRIP - 3

New Product Announcement GROOVE TURN Chipbreaker Elements Variable width in the frontal land for earlier chip control at low feed rates Side turning land with constantly varying rake angle for better chip formation Deflector with a wavy contour Optimized radius area for excellent chip control in small ap for both partial grooving and finish turning “F” style frontal deflector for improved chip control in full width grooving (5, 6 mm width only

Open the catalog to page 3
CUT-GRIP - 4

New Product Announcement GROOVE TURN Chip Control Range GIMT 608

Open the catalog to page 4
CUT-GRIP - 5

New Product Announcement GROOVE TURN Application: Grooving Workpiece Material: SAE 4340 Insert: GIMT 304 Vc: 120 m/min f mm/rev ap mm Application: Turning Workpiece Material: SAE 4340 Insert: GIMT 304 Vc: 120 m/min f mm/rev ap mm 0.12

Open the catalog to page 5
CUT-GRIP - 6

New Product Announcement GROOVE TURN TEST REPORTS GIMT 3 ISCAR Insert External Grooving TEST REPORTS GIMT 4 ISCAR Insert External Grooving TEST REPORTS GIMT 6 ISCAR Insert Material Operation 6 mm Grooving Insert Steel 20MnCr5 External Grooving

Open the catalog to page 6
CUT-GRIP - 7

GROOVE TURN march 2018 • metric 25-2018 GIMT Utility Single-Ended Inserts for Grooving and Turning • Dmin for internal applications = 70 mm

Open the catalog to page 7

All ISCAR Tools catalogs and technical brochures

  1. MILLING

    11 Pages

  2. THREADING

    5 Pages

  3. ITSBORE

    6 Pages

  4. COMBICHAM

    5 Pages

  5. SWISS-CUT

    9 Pages

  6. TANG-GRIP IQ

    40 Pages

  7. FLASHTURN

    28 Pages

  8. ISCAR INdustry

    24 Pages

  9. catalog 2015

    324 Pages

  10. JET HP Line

    60 Pages

  11. Heat Exchanger

    28 Pages

  12. Milling systems

    593 Pages

  13. TANG-GRIP

    40 Pages

  14. FLASH-TURN

    28 Pages

  15. IQ New Products

    184 Pages

  16. GrooveTurn

    372 Pages

Archived catalogs

  1. Combicham

    4 Pages