£L IRIS INSTRUMENTS RESISTIVITY AND INDUCED POLARISATION POWER TRANSMITTER > 3000 W - 2500 V - 13 A > MASTER-SLAVE MODE 6000 W - 5000 V - 13 A > EASE OF USE > ROBUSTNESS > STAN DARD MOTOR GENERATOR TECHNICAL SPECIFICATIONS 3000 W OUTPUT POWER 2500 V OUTPUT VOLTAGE 13 A OUTPUT CURRENT STANDARD MOTOR GENERATOR 90 TO 260 VAC, 50 OR 60 HZ, SINGLE PHASE TIME DOMAIN MODE TIPIX 3000 MAJOR BENEFITS AND FEATURES • TIPIX 3000 is a 3 kW transmitter designed for time domain IP and deep resistivity surveys. It will generate up to 2500 V for work in resistive areas and up to 13 A for low resistivity regions. • Master-Slave mode to double both voltage and power on high contact resistance environments. The maximum power of 6 kW and maximum voltage of 5000 V allow to work in very resistive environments. TIPIX 3000 can also be used in series together with a TIPIX 2200. • A four line alphanumeric display provides simultaneous and continuous indication of output current, voltage, power and contact resistance. • A standard single phase motor generator can be used to power the TIPIX. • GPS synchronisation for multiple injection at the same time using several TIPIX connected to different pairs of A and B electrodes, allowing to increase the reception signal. • Optimal current injection in one press with the automatic selection of the best voltage range according to the contact resistance. A manual selection can also be used with 5 or 12 steps. • Self-tests performed at the start of the system checking the proper functionning of main components. Messages and warnings are displayed for a better identification of trouble and a quicker instruments servicing. • Limit values of voltage, current or power can be introduced in the system. WAVEFORM : ON+,OFF,ON-,OFF OR ON+,ON-TIME BASE : 0.5, 1, 2, 4 AND 8 S PROTECTION: SHORT CIRCUIT OPEN LOOP THERMAL INPUT OVERVOLTAGE INPUT UNDERVOLTAGE EMERGENCY STOP BUTTON DIMENSIONS (L*W*H): 41 X 24 X 32 CM FIBERGLASS WEATHERPROOF CASING WEIGHT: 31 KG OPERATING TEMP: -40°C TO +60°C CONTACT : [email protected]

TIPIX 3000 DIFFERENT POSSIBILITIES TO USE SEVERAL TIPIX TRANSMITTERS AT THE SAME TIME TO INCREASE YOUR RECEPTION SIGNAL MASTER-SLAVE MODE The MASTER-SLAVE mode allows to connect two TIPIX in series, whatever their power. This type of connection adds the maximum voltage and power of the two systems to increase the amount of current injected on medium to high contact resistance values. The MASTER-SLAVE mode is very adapted to medium to high contact resistance environments. However, increasing the current injected by the system in low contact resistance environment can be done using several synchronized...