EXHAUST BLOWER BLH2A150202
1 / 2Pages

Catalog excerpts

EXHAUST BLOWER BLH2A150202 - 1

EXHAUST BLOWER Airtight version AC shaded pole motor with impeller Ø150x20mm CCW Rated voltage Rated frequency Rated current Rated power Speed ① Air flow ② Static pressure ② Noise ③ Note: Operating temperature Hot gas temperature Operating humidity Impeller rotation IP rate Type of service Config. ref. from -25°C to +80°C 250 °C (300°C peaks) 10 – 90 % R.H. (no condensation) CCW (look at the motor) IP 00 S1, S8 (continuous) L15007D At max air flow condition. Max value with our volute VACB000001 model. ③ Sound pressure level at 1m and max air flow condition ② Ground Terminal Electrical and mechanical characteristics Insulation Class Class H Appliance Class Class 0I Capacitor value ④ Dielectric strength test 1800V 50Hz for 1 s Thermal protector 145°C Impeller Ball bearing Damper washer Electrical wires Insulated disc Material list Stainless steel AISI 430 626Z 19x6x6mm shielded Silicon rubber - Note: ④ the capacitor is not supplied, unless otherwise agreed. Capacitor has to be in compliance with IEC EN 60252-1. The choice of S2 type (aluminium body) covers also the requests of 24.8 chapter of IEC EN 60335-1 standard, without have to apply the minimum distance required between the capacitor and the non-metallic parts. This revision replaces all previous versions of this document. IPC has done every effort to ensure that all information in this document is complete and correct at the time of publication. Due to possible product improvements, we reserve the right to change certain data in this document wi

Open the catalog to page 1
EXHAUST BLOWER BLH2A150202 - 2

EXHAUST BLOWER Airtight version AC shaded pole motor with impeller Ø150x20mm CCW Electrical connection and wiring diagram Electrical connections: Power: No. 2 male spade terminals 6,3x0,8mm on the bobbin of motor Grounding: male spade terminal 6,3x0,8mm on the stator of motor Tachometer connection: as PCB headers KK254 Molex series. Square pins 0,64mm 2,54mm pitch Pin Nr Function External components IN OUT 1 Vcc 5V – 20V Resistor so that the current will be Hall sensor within 0,5mA – 2mA max 3 Vout Output tachometer signal connection (1pulse/rev) Vout = Vcc 2 Gnd 0V Standard applied Low...

Open the catalog to page 2

All IPC catalogs and technical brochures