CENTRIFUGAL FAN CFH21203H501
2Pages

{{requestButtons}}

Catalog excerpts

CENTRIFUGAL FAN CFH21203H501 - 1

CENTRIFUGAL FAN AC shaded pole motor with impeller Ø125x30mm motor on the right and elbow 90° Ø80mm CW Rated voltage Rated frequency Rated current Rated power Speed ① Max air flow Max static pressure Noise ② Note: Starting voltage Operating temperature Hot gas temperature Operating humidity Impeller rotation IP rate Type of service Config. Ref. 100 V from -20°C to +50°C +150°C max 10 – 90 % R.H. (no condensation) CW (look at the impeller) IP 00 S1, S8 (continuous) L12508 At max air flow condition. Sound pressure level at 1m and max air flow condition Drawing 132 Pressure Prob. Ø6mm cover by silicon cap Ground Terminal Electrical and mechanical characteristics Insulation Class Class H Appliance Class Class 0I Dielectric strength test 1800V 50Hz for 1 s Motor protection By impedance Mounting position Any Thermal Protector - Housing Impeller Motor bearings Motor damper Electrical wires Additional supp. Material list Aluminized steel sheet Galvanized steel sheet Shielded ball bearings Silicone rubber 50 Shore A - This revision replaces all previous versions of this document. IPC has done every effort to ensure that all information in this document is complete and correct at the time of publication. Due to possible product improvements, we reserve the right to change certain data in this document without prior no

Open the catalog to page 1
CENTRIFUGAL FAN CFH21203H501 - 2

AC shaded pole motor with impeller Ø125x30mm motor on the right and elbow 90° Ø80mm CW Electrical connection and wiring diagram Electrical connections: Feeding: male spade terminals 6,3x0,8mm Grounding: male spade terminal 6,3x0,8mm Standard applied Low Voltage Directive: EN 60335-1 EMC Directive: Emission – EN 55014-1, EN 61000-3-2 and 61000-3-3 Immunity – EN 55014-2 Mounting positions All positions are admissible, with the rotation axis in horizontal, vertical or in other intermediate positions. Please pay attention: the temperature around the motor must not rise over the max admissible...

Open the catalog to page 2

All IPC catalogs and technical brochures