*mydirectindustry

RM6008

Product catalog summary

Product Description: The Interroll Lift is a vertical conveyor featuring a column construction and a carriage for mounting conveyor components. It operates using two toothed belts with the drive located at the top. An encoder can be integrated, and the lift supports higher speeds and multiple approach positions.

Technical Data:

Max. Load Capacity: 260 kg (includes material, fork, and conveyor weight; varies with design)
Stroke Velocity: 0.1 to 1.0 m/s
Ambient Temperature: -5 to +40 °C
Max. Stroke Height: 8000 mm
Startup Positions: Minimum 2
Lifting Column: 200 x 80 mm (Aluminum profile)
Drive Motor Type: Worm gear motor with brake (IE3, frequency regulation on site)
Rated Voltage: 400 V / 50 Hz / 3 Phases
Max. Electrical Power: 1.5 to 3.0 KW
Drive Medium: Toothed belt

Dimensions:

BF (Between Frames): 420, 620, 840 mm, others on request
H1 (Upper Lever Dimension): Min. 500 mm
H2 (Lower Lever Dimension): H1 + stroke height
H (Height): H2 + 675 mm (BF 420) / +875 mm (BF 620) / +1095 mm (BF 840)
CW (Width of Mounted Conveyors): Max. 1300 mm
ML (Width of Mounted Conveyors): Max. 1440 mm (special fork may be required if longer)

Note: The upper part of the lifting station must be supported on site above an overall height of 4000 mm.

Scope of Supply:

The module is fully assembled, including sensor system, but not electrically cabled.
Energy chain is pre-installed.
Protective grid and safety elements must be requested separately.
Conveyor module is not included.

Catalog excerpts

RM6008Interroll Lift Product description This vertical conveyor consists of a column construction and a carriage upon which conveyor components can be mounted. Lifting motion is performed by two toothed belts. The planned drive is located at the top. Integrating an encoder is possible. This lift can optionally be used at higher speeds and in several approach positions. Technical Data General technical data Lifting column_200 x 80 mm (Aluminum profile) Drive Motor type Worm gear motor with brake (IE3, frequency regulation on site) Rated voltage 400 V / 50 Hz / 3 Phases Drive medium Toothed belt Max. load capacity consists of material to be conveyed, fork weight and conveyor weight and can vary depending on the design of the conveyor and the lifting fork type.

Open the catalog to page 1

Between frames Upper lever dimension Lower lever dimension Height Width of mounted conveyors Width of mounted conveyors** 420, 620, 840 mm, others on request Min. 500 mm H1 + stroke height H2 + 675 mm (BF 420) / +875 mm (BF 620) / +1095 mm (BF 840) Max. 1300 mm Max. 1440 mm ** If mounted conveyor is longer, a special fork may be required! Note: The upper part of the lifting station must be supported on site above an overall height of 4000 mm. The module is fully assembled, including sensor system, but is not electrically cabled. Energy chain

Open the catalog to page 2

All Interroll catalogs and technical brochures