ITR700-001 - KNX RF 2 CHANNEL PUSH BUTTON INTERFACE Interra ITR700-001 is a 2 pushbutton input wireless KNX RF S-Mode transmitter with a built-in temperature sensor. ITR700-001 is a perfect solution for using in conventional installations without placing KNX bus cables. Communication with the KNX Bus must be carried out using a ITR750-002 KNX RF S-Mode media coupler. Interra ITR700-001 KNX RF push button interface detects the status changes at its inputs and send telegrams according to ETS configuration. In addition, it also allows the measurement of the temperature and the management of temperature alarms. Each of 2 inputs can be parameterized individually through the ETS. Device Power Supply Battery life (esteemed) Radio Frequency Transmission Power Transmission Range FUNCTIONS & CHARACTERISTICS • Acting on 1 or 2 independent output channels. • Function of each input : Switch, Timed Start/Stop, Dimmer, Multiple Switch, Shutter control, Scene control, Fixed value/ • The Temperature Sensor incorporates different options that must be parameterized: Transmission frequency, over-heating or KNX-RF S-Mode Temperature accuracy over-cooling alarms and temperature sensor calibration. Temperature Range Non-flammable Product Light Grey Dimensions Certification Configuration • Flush mounting within an universal box, behind a pushbutton. INSTALLATION The range of the radio signal depends on various external states. The range can be optimized by the choice of installation location avoiding placing it close to any possible sources of interference, e.g. metallic surfaces, microwave ovens. Fig. 1 SAFETY NOTES BATTERY CHANGE Avoid to install it close to radio electrical devices, microwaves,… When the battery reaches the limit of its life, ITR700-001 sends a warning Leave a minimum separation of 2m between the transmitter and telegram to KNX bus. To replace the battery (Fig. 1) release the cover of the sensor with the help of a screwdriver. Insert it into the upper slot. Remove the cover of the socle and remove the battery being careful with May be used for indoor installations in dry rooms only. the components of the printed circuit. DS200925175AE