ITR500-001 - 6CH 10A BALLAST DIMMING MODULE DESCRIPTION ITR500-001 can dimming from 0V to 10V for per channel. The outputs for MAX 10A be switched ON or OFF on every output channel, also can manually switch. Control types include both input • Screw down strength is less than 0.4Nm. • Rain, liquid and aggressive gas are not allowed to be close to device. • Do not get AC 240V voltage into Bus wire, it will damage all of devices in system. and output, so, Absorption and output type ballast can be connected to this module. FUNCTIONS Device Power Supply • 6 Channel 0-10V dimming and maximum 10A relay output for every channel. also can manually switch. • The switch functions: Statistical total ON time, Status response, Current Consumption Dimming Output Channel Current INSTALLATION STEPS • Labeling for AC power wires, loads wires and KNX/EIB wire. Temperature Range Non-flammable product Light grey and white • Mount the device on a DIN rail of distribution box. • Connect wires for loads. • Make sure there is no short circuit or open circuit. • Make sure the KNX cable type is correct and has no short circuit. • Connect KNX cables. Make sure the color is correct. • Tidy the all Wire and separate KNX wire from AC power wire. IMPORTANT NOTES • Special Programming: This device is designed for professional KNX installation. It can only be programmed by ETS software. • Check Connections: Re-tighten all connections after installation. • Output Circuit: The load on the switched circuits must not exceed the specified capacity of 10A, these circuits should be fed via a 10A fuse/circuit breaker control, Scene dimming, Sequence control, Threshold switch, Manual Button Button and LED Status recovery, Upper limit, Lower limit, Staircase light, Sce