ITR410-003 - OUTDOOR KNX MOVABLE DESCRIPTION ITR410-003 - Outdoor KNX Movable Motion Sensor is a multi- • ITR410-003 supports movement and LUX detection. functional light level and movement detector. ITR410-003 includes 5 MOTION SENSOR • Adjustable from approximately 10 Lux to ∞ and Lux learning range: 10 outputs for Lighting, HVAC and Alarm control operations. The sensor should be programmed via most current ETS software. Moreover, to avoid thermal problems at high temperatures, the sensor is designed with temperature compensated circuit. ITR410-003 can be used at proper location such as home, office, building entrance, hotel, stairs, yard, parking area, corridor etc. IMPORTANT NOTES Device Power Supply Current Consumption 10 mA (dynamic) 5 mA (static) 2 x Lighting outputs 2 x HVAC outputs 1 x Alarm output Installation Height Detection Range KNX installation. It can be programmed by ETS software. • Cable Connections: Ensure making correct connections for Black and Red wires. • Voltage: The input voltage shall be 21-30VDC. • Mounting Location: Installation at outdoors, to avoid installation near the air-conditioner vent, and be away from the heat source. • Do not get 240 V AC voltage into Bus wire. LED is for indicating ETS installation. Moreover, the LED function can be disabled by ETS. • Detector head adjustment: 90° left, 90° right, 90° up and 40° down. • Alarm function can be set for switch ON and switch OFF. Also, alarm output can be locked. DETECTING The sensor should be mounted a proper location at 2-3 m. The advised mounting height is 2.5m to achieve optimal detection range. • A red LED is equipped as an indicator for test triggering and a blue Temperature Range • Special Programming: ITR410-003 is designed for professional • Delay Off Time Adjustment: Several adjustments: 1sec, 5sec, 30sec, Detection Angle • Load on Illumination in Standby Mode: Several adjustments: 1%, 2%, Light Grey and White Ceiling Mount Wall Mount Wall Mount: 150x84x90 (WxHxD) Ceiling Mount: 166x111x90 (WxHxD)

USEFUL INSTALLATION TIPS As the sensor reacts to temperature changes, the following conditions should be avoided: Please strip off 6-8 mm of cables sheathing by tool before installation. Feed the electric cables through rubber gasket for correct wiring, then fit the bottom cover by two screws. OPERATIONS The purpose of conducting walk test is to check and adjust the detection coverage. Set Time knob to "Test" for conducting walk test. Lux value is invalid in Test mode. Avoid targeting the sensor toward the objects which may be swayed in the wind, such as curtain, tall plants, miniature Walk Test...