International Polymer Solutions Inc. is proud to introduce our new line of PTFE Chemical Injection Control Valves. Offering precision performance under extreme conditions, our all-wetted PTFE design is ideally suited for chemical wet process in water, wastewater, pharmaceutical, life science and general chemical handling applications. The PTFE construction guarantees best-in-class inert characteristics for high purity applications and exceptional chemical resistant behavior for corrosive applications. With a wide range of options available, our IPS Chemical Injection Control Valve can solve the most challenging Chemical Dosing problem. Whether injecting Fluoride, Chlorine, Chlorine Dioxide, Ammonia, Sulfuric Acid, Nitric Acid, Peracetic Acid or any number of other process chemistries, our PTFE Chemical Injection Control Valve will self-regulate and control the dosing flow rate to gallons per hour (GPH) of injected chemistry. Our IPS PTFE Chemical Injection Control Valve is factory configured with a PTFE Pressure Regulator allowing for a wide range of inlet source pressures from fixed Chemical Storage Tanks and Vessels. The days of manually adjusting over time for large inlet pressure variation are gone. The Control Valve design incorporates a quarter-turn tapered orifice which modulates the media flow up to a 10:1 ratio. Porting Options: • te” FNPT Connection • te” ANSI 150# Flange Connection • te” Mini Sanitary Connection • 1” Ladish Sanitary Connection Quarter-Turn Actuation Options: • Electromechanical 4 to 20ma Control Signal • Electromechanical On/Off with Return Spring • Pneumatic On/Off with Return Spring • Manual Actuation with Topside Hand Lever Inlet Pressure Regulation: • 2 psi to 20 psi Fixed Set Point Pressure Regulation to Control Valve • Source Pressure at Pressure Regulator Inlet from set point up to 80 psi Control Valve Flow Characteristics: h • Configurable Fixed Tapered Orifice on PTFE Ball • Flow Configuration A: 2 to 12 GPH max (with zero flow when closed) • Flow Configuration B: 4 to 32 GPH max (with zero flow when closed) • Flow Configuration C: 6 to 60 GPH max (with zero flow when closed) • Flow Configuration D: 10 to 100 GPH max (with zero flow when closed) • Liquid Tight ANSI/FCI 70-2:2006 Class V Valve Seat Leakage (< 0.0002 GPH) Call IPS with your unique Flow Requirements manufacturing TOKom illternational polymer solutions inc. • manufacturer of high purity flow control products www.ipolymer.com | info@i

• PTFE design optimized for inert high purity, chemical resistance and food safe use • Ideally suited for harsh chemical media and elevated media temperatures • All sealing surfaces are PTFE hard seated or diaphragm seals • Actuation is rated for a continuous control duty cycle General Parameters: Options Available on Request: • Orifice Cv (depending on design) • Media Temperature (range) • Ambient Temperature (range) • Special Port Configurations • End of Travel Limit Switches • Continuous Position Feedback • Maximum Port Pressure Rating (psi) at Regulator inlet 80 psi at Ball Valve outlet 20...