E3Z phtotelectric sensor with distance and mode setting

Product catalog summary

Introduction
This document is the instruction manual for the IMS E3Z Photoelectric Sensor. It provides essential precautions for installation and operation to ensure safety and optimal performance. Users are advised to read thoroughly before use and keep the manual accessible.

Safety Precautions

Install a fail-safe device when using the sensor with machinery that could cause serious injury or economic loss.
Avoid using the sensor over its rated voltage, in environments with flammable gases, or where there is vibration or impact.
Do not clean the unit with water or oil-based detergents.

Features

High-performance ASIC-based sensor with a long lifespan.
Built-in protections: power-on delay, short circuit, reverse polarity, and over-voltage.
Excellent noise immunity and visible red light for easy alignment.
IP65 protection grade.

Specifications

Sensing methods include through-beam, diffuse reflective, and retro-reflective.
Response time is a maximum of 1ms with a current consumption of up to 25mA.
Operating temperature ranges from -25°C to 55°C.
Material includes ABS for the case and PMMA for the lens.

Installation and Usage Guidelines

Ensure correct wiring before powering on.
Prevent direct sunlight or spotlight from entering the sensor's angle.
Maintain adequate spacing between sensors to avoid interference.
Use separate wiring for high voltage lines to prevent damage.
Clean the lens with a dry cloth, avoiding chemical solvents.

Connection and Circuit Protection

Details on NPN and PNP open collector outputs are provided.
Maximum load current is 100mA with overcurrent protection.

Contact Information
For further assistance, contact Intellisense Microelectronics at the provided phone numbers or email address.

Catalog excerpts

E3Z phtotelectric sensor with distance and mode setting-1

IMS E3z-nnnn Mini-Square Photoelectric Sensor INSTRUCTION MANUAL ! WARNING Thank you for selecting IMS product.This sheet primarily describes precautions required in installing and operating the product.Before operating the product,read the sheet thoroughly to acquire sufficient knowledge of the product.For your convenience,keep the sheet at your disposal. ! CAUTION Failure to follow these instructions may result in serious injury or death: Fail-safe device must be installed when using the unit with machinery that may cause serious injury or substantial economic loss. (e.g. nuclear power control, medical equipment, ships, vehicles, railways, aircraft, combustion apparatus, safety equipment, crime/disaster prevention devices,etc.) Failure to follow these instructions may result in product damage: Do not use this unit over rated voltage; Do not use this unit where there is flammable or explosive gas; Do not use this unit where there is vibration or impact; In cleaning the unit, do not use water or an oil-based detergent. □ Features • High performance ASIC based advance sensor • Long product life time, 5us modulated pulse with 1/10 duty cycle reduced aging of LED • Build in 100ms power on delay, self-recover short circuit protection, reverse polarity, over voltage protection • Excellent noise immunity to DC light with modulated light source and CDS signal process technology • Mode selection for light on and dark on • Visible super bright red light for easy alignment • IP65 grade Sensing method □ Operating timing diagram

Open the catalog to page 1

E3Z phtotelectric sensor with distance and mode setting-2

■ Connection • Through-beam Emitter • Diffuse reflective/Retro reflective Target object Vinyl insulated round cord 4 dia. 3 cores (conductor cross sectional area:0.2mm2(AWG24) /insulation outside diameter:1.1 dia.) standard length 2m □ Main product • Photoelectric sensor • Light curtain • Proximity sensor • Pressure sensor • Counting sensor • Distance sensor Liquid level sensor Label sensor Hall sensor Pressure meter Counting machine Dust sensor Intellisense Microelectronics Tel:0592-8268993 Tax:0592-8268997 Web:www.chinasensors.cn E-mail:[email protected] Add:1F NO. 34 Guanri Rd, Xiamen...

Open the catalog to page 2