Model E3sio-nnan INSTRUCTION MANUAL ! WARNING Thank you for selecting IMS product.This sheet primarily describes precautions required in installing and operating the product.Before operating the product,read the sheet thoroughly to acquire sufficient knowledge of the product.For your convenience,keep the sheet at your disposal. Failure to follow these instructions may result in serious injury or death: Fail-safe device must be installed when using the unit with machinery that may cause serious injury or substantial economic loss. (e.g. nuclear power control medical equipment, ships, vehicles, railways, aircraft, combustion apparatus, safety equipment, crime/disaster prevention devices,etc.) Failure to follow these instructions may result in product damage: Do not use this unit over rated voltage; Do not use this unit where there is flammable or explosive gas; Do not use this unit where there is vibration or impact; In cleaning the unit, do not use water or an oil-based detergent. Features • High performance ASIC based advance sensor • Sensitivity adjust • Red LED or infrared LED • High response time:1ms or 0.25ms • Power supply reverse polarity protection, Output short-circuit protection and over current protection • Built in self-recover output short circuit protection • The transmitter and receiver are embedded in a u-shaped housing to simplify installation and alignment • Applicable to label detection, hole or gear edge counting Sensing method □ Operating timing diagram — ( Light source code ) Connection type Response time Sensitivity Operation mode Sensing distance unit Sensing distance ( slot series use 30/50 to refer slot distance ) Sensing method ( slot series is none ) available Fixed_ Light on Dark on Selectable Number) Sensing distance ^ The waveforms of"Operation indicator"and" Transistor output"are for Light on mode.

Control output circuit diagram Main product Photoelectric sensor Light curtain Proximity sensor Pressure sensor Counting sensor Distance sensor Four wires-NPN open collector output （Brown）+V Stability （green） Main circuit Over current protection Four wires-PNP open collector output （Brown）+V Over current protection Main circuit Stability （green） （Blue）0V （white） Dark ON control Light ON Optical axis Stability indicator Green） （ Sensitivity adjuster Operation indicator（Red） Caution for using 1、Please make sure the wiring is correct before power-on. 2、Use a visor or a hood so that excessive light（e.g....