The Instron® 2716-030 Series precision manual wedge grips deliver dependable performance and precise alignment for tensile testing across a broad spectrum of materials - including composites, metals, and other rigid specimens. Designed to meet the stringent alignment requirements of Nadcap AC7122 and AC7101, these grips ensure consistent and repeatable results1. These manual, self-centering wedge grips utilize a moving body design to provide secure and symmetrical clamping. Initial gripping force is applied manually via a ratchet handle, and as the test load increases, the wedge mechanism increases the gripping force proportionally. A worm gear drive enables smooth, synchronized jaw movement, ensuring accurate specimen alignment throughout the test. The grips are engineered for ease of use and enhanced productivity. Jaw faces can be swapped in seconds without tools, and “piggyback" adapters allow for quick integration of fixtures for compression or flex tests - without removing the grips from the system. • Safe, ergonomic ratchet handle for manual operation • Self-centering moving body design ensures precise alignment compliant with Nadcap requirements • Tool-free jaw face replacement for fast setup changes • Wide operating temperature range: -80 to +250 °C (-112 to +482 °F) without part or lubricant changes • Adjustable specimen stop for consistent positioning • Robust gripping performance with repeatable results • Enclosed design protects against dirt and debris • Multiple jaw face sizes and surface options available • Piggyback adapters enable fixture installation without grip removal 1. New 6800 Series systems with factory fitted grips meet the alignment specifications in the current Nadcap checklists. Achievement of Nadcap alignment specifications is critically dependent on the total testing system configuration and cannot be guaranteed, solely, by using 2716-030 grips. If you require Nadcap certification, then this must be discussed directly with Instron to ensure the suitability of your testing system.

2716-030 Series | Precision Manual Wedge Grips • Static tensile tests on a variety of materials including composites, metals, and plastics over a range of temperatures • Type of loading: Tensile, static, and tension-tension cyclic tests; not suitable for high-cycle dynamic fatigue tests • Specimen shapes: Flat and round • Compatible with a variety of composite test fixtures via piggyback adapters Maximum Force Capacity 1. Maximum specimen thickness depends on jaw face selection. See Jaw Faces table on page 4.

2716-030 Series | Precision Manual Wedge Grips OPTIONAL ACCESSORIES FOR IMPROVED PRODUCTIVITY, EASE OF USE, AND REPEATABILITY SPECIMEN CENTERING STOPS PULL RODS Fitted to both the upper and lower grip, the optional specimen alignment device ensures that the specimen is positioned consistently for every test. Pull rod extenders allow the grips to be used inside of a temperature chamber. PIGGYBACK COMPRESSION PLATENS AND ADAPTERS Compression platens and adapters allow the testing machine to be configured for compression and other testing without having to remove the grips. OPTIONAL ITEMS FOR USE...

2716-030 Series | Precision Manual Wedge Grips JAW FACES FOR 2716-030 250 KN GRIPS Catalog Carbide Coated Carbide Coated Carbide Coated IN RON* Worldwide Headquarters European Headquarters 825 University Ave, Norwood, MA 02062-2643, USA Coronation Road, High Wycombe, Bucks HP12 3SY, UK Instron is a registered trademark of Illinois Tool Works Inc. (ITW). Other names, logos, icons and marks identifying Instron products and services referenced herein are trademarks of ITW and may not be used without the prior written permission of ITW. Other product and company names listed are trademarks or trade...