Catalogs >
Instron >
3 Point 4 Point Bend Fixture 2810-600

3 Point 4 Point Bend Fixture 2810-600
2Pages

Catalog excerpts

3 Point 4 Point Bend Fixture 2810-600 - 1

3-Point and 4-Point Bend Fixture Principle of Operation Suitable for both low force dynamic and static testing along with dental standards ISO 9917, ISO 6872, ISO 4049 or ISO 20795 the low-force 3-Point bend fixture is designed to be compatible with ElectroPuls E1000. The specimen is supported on two lower anvils and the load is applied in the center of the specimen by a single upper anvil. The t-slot base allows adjustment of the lower span from 15 - 80mm (0.59 - 3.15in) allowing for variable specimen lengths and is submersible to be compatible with an optional fluid bath and recirculator. Features • Corrosion-resistant stainless steel construction • 3 kN (675 lbf) capacity • Support span 15 – 80 mm (0.59 – 3.15 in) Application Range • Bend testing of small components, plastics, wood, and composites • Specimen shapes: Flat and round • Suitable for both static & fatigue testing • Compatible with ElectroPuls E1000 Specifications 2810-600 Maximum Force Capacity Upper Fitting Lower Fitting Support Span Specimen Width Anvil Diameter

Open the catalog to page 1

3 Point 4 Point Bend Fixture 2810-600 - 2

Optional Accessories 4-Point Bend Fixture Conversion Kit (2810-605): used to convert 2810-600 from a 3-point to a 4-point bend fixture. The 4-point bend conversion kit has a variable upper span of 5 - 40mm (0.19-1.57in). The test specimen is supported on two lower anvils whilst the load is evenly applied by two upper anvils. Optional Items for use with 2810-600 Catalog Number 2810-605 Description 4-Point Bend Conversion Kit www.instron.com Worldwide Headquarters 825 University Ave, Norwood, MA 02062-2643, USA Tel: +1 800 564 8378 or +1 781 575 5000 European Headquarters Coronation Road,...

Open the catalog to page 2