Catalogs >
Innovative Sensor Technology IST AG >
P14 2FW Thermo Brochure en

P14 2FW Thermo Brochure en
3Pages

Catalog excerpts

Capacitive Humidity Sensor Optimal for weather balloons / radiosondes with on-chip heater and temperature sensor Extraordinary fast response time: 3 x faster than P14 Rapid Humidity sensor with on-chip heater / temperature sensor Outstanding sensitivity Temperature shock resistant High humidity stability Fast recovery time after condensation Customer-specific sensor available upon request Robust against icing 1) For actual size, see mechanical dimensions Technical Data Back side: Heater / temperature sensor Front side: humidity sensor Operating humidity range: Operating temperature range: Heater / temperature sensor:* IEC60751 ±1%: ±(2.59 + 0.05 x |T|) °C |T| = absolute value of temperature in °C Loss factor: Linearity error: 2) High accuracy temperature sensor on request 3) The response time is often measured for increasing humidity steps,whereas physics predicts that decreasing humidity leads to generally far longer response times for capacitive humidity sensors. IST AG thus measures response times always for decreasing humidity values, since this is the worst case. Measurement frequency range: Maximal supply voltage: Signal form: alternating signal without DC bias CuP-SIL wire post-plated with Sn, 10 mm W x H: 0.5 x 0.25 mm with 1.27 mm pitch * Customer-specific alternatives available DHP14-Rapid-2-Thermo_E2.3.1_preliminary | Humidity Sensor | P1

Open the catalog to page 1

The calibration of the sensor must be done 5 days after soldering at the earliest. Mechanical Dimensions humidity sensor temperature sensor temperature sensor humidity sensor Response time (typical) 100.0 DHP14-Rapid-2-Thermo_E2.3.1_preliminary | Humidity Sensor | P14 Rapid 2 Thermo 2/3

Open the catalog to page 2

Characteristic Curve (typical) Product Photo Order Information - CuP-SIL wire post-plated with Sn, 10 mm Nominal resistance: 100 Ω at 0 °C Order code Former order code Innovative Sensor Technology IST AG, Stegrütistrasse 14, 9642 Ebnat-Kappel, Switzerland Phone: +41 71 992 01 00 | Fax: +41 71 992 01 99 | Email: info@ist-ag.com | www.ist-ag.com All mechanical dimensions are valid at 25 °C ambient temperature, if not differently indicated • All data except the mechanical dimensions only have information purposes and are not to be understood as assured characteristics • Technical changes...

Open the catalog to page 3

P14 2FW Thermo Brochure en 3Pages

Catalog excerpts

All Innovative Sensor Technology IST AG catalogs and technical brochures

P14 2FW Thermo Brochure en
3Pages