Wet End Tail Cutters
2Pages

ProJet BV Industrial Zone Weerterveld 51 6231 NC Meerssen, The Netherlands PO Box 32 6230AA Meerssen, The Netherlands Tel +31-43-365-3100 Fax +31-43-365-3832 info@pro-jet.nl www.pro-jet.nl Single Tail Cutter Features: Park position outside machine on ts or ds Complete constuction aisi 316ti throughout Motor with variable speed inventor Tail width is fine adjustable - Compact designs to fit any machine. - Motor drive on tending- or drive side possible. - Hand crank on drive and tending side. - Stainless steel 316 construction throughout. - Variable speed drive system. - Encoder for precise position control. - Easy integration of system controls into existing PLC or DCS system. Cantilever contruction available Dual Tail Cutter set sheet width adjust sheet symmetrically - Automatic trim removal before the couch and size press. - Eliminates changing deckle widths of suction and press rolls. - Substantial savings in drying energy possible if trim is removed at the wet-end instead of after the reel. Tail cutting with T&D cutter Cutting the Tail - Adjusting the paper width to cross directional shrink. * Minimum paper loss at pope roller. adjust sheet on one side only - Parameter feedback “End of production run” or “All parameters ready to go for new production run”. * Unproductive time between production runs is minimized. quick cut off at sheet break to avoid - Setting the Tail width. * Quickest possible adjustments. paper pile up in driver section - Choosing the position of the Tail. * Best position of the press rolls or press felts. - Choice for dual speed. * Optimal speed for “Go to full width” and thus minimizing the risk for sheet breaks. * Highest possible speed at “Cut off” and thus reducing scrap to a minimum. - Remote control. * Operating personnel does not need to wait at the forming section during tail transfer. - Reducti

ProJet BV Industrial Zone Weerterveld 51 6231 NC Meerssen, The Netherlands PO Box 32 6230AA Meerssen, The Netherlands Tel +31-43-365-3100 O Pro Jet B. V. Professional high pressure water jet technology Features: - Saw blade penetrates in & out of stabilised sheet. - Compact tail cutter traverse beam. - Positive sheet support (Coanda-compressed air effect) for improved cutting. - Variable speed drive system includes encoder for precise position control. - Integration of system controls into PLC or existing DCS systems possible. Sheet support: Coanda effect - Eliminates flitting of the sheet....