►► TAPE CLAMPING BRACKETS (IEC 62.561-4) Mounting brackets for 30x2 mm for flat conductor. ► applications Attaching and tightening of capture system conductors and external lightning protection systems. Different diameters and anchor models depending on the type of structure (concrete, brick, metal plate, etc.). • Made of Cu / Zn (brass) alloy, stainless steel screws. • Pre-mounted models. • Corrosion resistant. Meets the environmental tests of IEC 62561-4. • Different attachment types depending on the type of structure: • Hollow wall (brick): Plug + lag screw model. • Solid wall (concrete): Metal plug + spike model. • Sheet metal: Self-tapping screws + leg model. Tools needed to install the M-6 spike model or M-8 metal plug: • Drilling machine • 6 mm drill bit • Punch, hammer and screwdriver 1. Make a hole in the wall using a drill with appropriate bit. 2. Put the metal plug into the hole Fig. 1. 3. With the plug in the hole, use a punch and a hammer so that the pin penetrates inside the heel towards the lower end of the plug, opening the legs to secure it. 4. Once the stud is securely attached, thread the stud and the bottom of the clamp Fig. 2, check that it is well threaded and the anchor is strong. 5. Insert the plate into the bottom of the bracket that is already fixed, and place the top piece of the same, securing it with the screws supplied Fig. 3 and 4.

TAPE CLAMPING BRACKET (IEC 62.561-4) Duero 5 | 08223 Terrassa | Barcelona | Spain T 937 360 305 | T (+34) 937 360 314 F 937 360 312 [email protected]