Key Features • 128 x 64 monochrome LCD display • MicroSD™ data storage • Real time clock • 1 CAN Port, 1 RS-232, 1 RS-485 • Addressable function keys • IP65 (NEMA 4X) • Free configuration software c € ® Rg Standard Options DI DO AI AO Programmable Keys 14 Programmable Keys X Digital Input 12 Digital Inputs 10 Analogue Input 4 (12 Bit) D Technical Datasheet For more information visit www.imopc.com Errors and omissions excepted. Subject to change without notice. © 2018 IMO Precision Controls Ltd REF: i3AL Datasheet 0618

Technical Specifications Technical Datasheet General Specifications Control & Logic Specifications Required Power (Steady State) Display Specifications Control Language Support Display Type Serial Ports I/O Specifications Digital DC Inputs Digital Relay Outputs Digital DC Outputs - Sinking (PWM Digital DC Outputs - Sourcing For more information visit www.imopc.com Errors and omissions excepted. Subject to change without notice. © 2018 IMO Precision Controls Ltd

Technical Datasheet Input Ranges Analogue Outputs Number of Channels Minimum Current Load Approvals Certifications Function Keys High Capacity MicroSD Slot USB Mini-B Port CAN Port (via RJ45) RS232/RS485 Serial Connector Analogue I/O DC Inputs DC Power DC Outputs Primary Power Port Pins DC Input / Frame Solid/Stranded wire; 12-24AWG (2.5-0.2mm). Strip length - 0.28” (7 mm) Torque rating: 4.5-7.0 in/lbs (0.50-0.78Nm) DC- is internally connected to I/O 0V Class 2 power supply must be used to meet UL requirements For more information visit www.imopc.com Errors and omissions excepted. Subject to...

Position / Pin Digital Model Technical Datasheet Model -10D14 Digital Out Position / Pin Digital Model Analogue Inputs Raw input values are found in the registers as Integer-type data with a range from 0 - 32000. Analogue input may be filtered digitally with the filter constant found in the i3 Configurator Hardware Configuration for Analogue Inputs. Valid filter values are 0-7 and act according to the following chart. Filter Constant The i3 can be wired for positive logic inputs or negative. For more information visit www.imopc.com Errors and omissions excepted. Subject to change without...

i3A Lite Intelligent Control Station CAN Communication Serial Communication IMP Technical Datasheet 8 ( Modular jack (8 posn RJ45) The CAN port is provided via the single 8-position modular jack labelled “CAN”. It may be used to communicate with other i3 modules using iCAN protocol. Additionally, remote expansion I/O such as Smart I/O may be implemented using the iCAN protocol. Termination for the CAN port may be enabled from the System Menu or System Register. This should only occur if the i3AL is at one end of the CAN network or the other. Only the two devices on either end of the CAN network...