■ 5.7” TFT Colour Touchscreen ■ 65,535 Colours, VGA (640 x 480) ■ MicroSD™ Data storage upto 32GB ■ Real Time Clock ■ 1 CAN Port, 3 RS-232 / RS-485 ■ 1 Integral Ethernet Port ■ USB Port for Programming ■ USB Port for Flash Drives upto 2TB ■ Addressable function keys ■ 1MB RAM (Program), 27MB (Graphical) ■ IP65 (NEMA4) ■ 10 - 30 VDC Power Supply ■ Online Programming ■ Free Configuration Software ■ Remote I/O Communication ■ Optional - Modem (SMS, GSM, GPRS) C€® Standard Options * Universal Analogue Inputs

TECHNICAL DATASHEET i CX Intelligent Control Station 3 Technical Specifications General Specifications Required Power (Steady State) Required Power (Inrush) Primary Voltage Range Relative Humidity Advanced Ladder Logic Full IEC 61131-3 Control Language Support Logic Program Size & Logic Scan Rate Online Programming Changes Supported in Advanced Ladder Clock Accuracy +/-20ppm Maximum at 25°C (+/-1 Minute per month) Operating Air Temperature Storage Temperature 50,000 (words) Retentive 16,384 (bits) Retentive 16,384 (bits) Non-retentive General Purpose Registers Display Specifications Display Type...

TECHNICAL DATASHEET DC Input / Frame Torque rating: 4.5-7 Lb-in (0.50-0.78Nm) DC- is internally connected to I/O V-, but is isolated from CAN VA Class 2 power supply must be used CAN Locking Spring-Clamp 2-Terminators Per Conductor Mounting screw torque rating: 4.5 Lb-in (0.50Nm) SHLD and V+ pins are not internally connected to i3CX Primary Power Port Pins Primary Power Port Pins 2 DC- Input Power Supply Ground 3 DC+ Input Power Supply Voltage Signal Description Direction V- CAN Ground - Black - CN L CAN Data Low - Blue IN / OUT SHLD Shield Ground - None -...

WARNING: Battery may explode if mistreated. Do not recharge, disassemble or dispose of in fire. WARNING: EXPLOSION HAZARD - BATTERIES MUST ONLY BE CHANGED IN AN AREA KNOWN TO BE NON-HAZARDOUS This equipment is suitable for use in Class 1, Division 2, Groups A, B, C and D or Non-hazardous locations only. FOR U.S. & CANADA ONLY Power input and output (I/O) wiring must be in accordance with Class 1, Division 2 wiring methods of the National Electric Code, NFPA70 for installations in the U.S. or as specified in Section 18-1J2 of the Canadian Electric Code for installations within Canada and in accordance...