index introduction > ● the productspages 2-3 > ● applicable standardspages 4-7 > ● reaction to chemical agentspage8 > ● use in electric systems in areas at risk of explosionpages 9-10 plugs and socket-outlets > ● ● general characteristicspage11 > ● ● the productspages 12-13 > ● ● detail of items pages 14-37 interlocked switched socket-outlets and accessories for distribution boards and groups > ● general characteristicspages 39-40 > ● the products - socket-outlets and accessoriespages 42-43 > ● detail of items - socket-outletspages 44-56 > ● detail of items - accessoriespages 58-65 interlocked switched socket-outlets and components for set mounting > ● general characteristicspages 67-68 > ● the products - socket-outlets and accessoriespages 70-71 > ● detail of items - socket-outletspages 72-82 > ● the accessoriespage83 > ● detail of items - accessoriespages 84-87 boxes for distribution boards > ● general characteristicspages 89-91 > ● the products - FC casespages 92-93 > ● detail of items - FC casespages 94-99 > ● the products - FC accessoriespage100 > ● detail of items - FC componentspages 101-104 cases for distribution boards > ● general characteristicspages 105-107 > ● the products - FM cases and accessoriespages 108-111 > ● detail of items - FM casespages 112-121 > ● detail of items - FM componentspages 122-126 > ● detail of items - Pluso accessoriespages 127-129 interlocked switched socket-outlets for distribution boards > ● general characteristicspages 131-132 > ● the products - FC and FM cases for SQ and SQ...socket-outlets page133 > ● detail of items - SQ socket-outletspage134 > ● detail of items - SQ...socket-outletspages 135-143 cases and socket-outlets for distribution boards > ● general characteristicspages 145-148 > ● the products - cases and BK modulespage149 > ● detail of items - BK modulespages 150-156 > ● detail of items - Pluso accessoriespage157 > ● detail of items - BK cases and other accessoriespages 158-161 other accessories > ● detail of items pages 163-166 >

page 11 to page 37 page 131 to page 143 >

page 105 to page 129 may be combined with:the Pluso series the SQ and SQ...series > page 89 to page 104 may be combined with:the Pluso series the SQ and SQ...series the PK, KI series, PB...T1 and T2 > page 145 to page 161 may be combined with:the Pluso series > pages 78-79-81-82 may be combined with:the Pluso series > page 39 to page 65 may be combined with:the Pluso series >

TTA type-tested assemblies (more likely mass-produced > The low voltage distribution boards, known as assemb lies Ӕby the definitions in EN60439 standard, contain the switchgear (for isolation, switching), protective devices(automatic circuit-breakers, fuses), and controlgear (for command, control and mea-surement), and are rarely suitable for mass-production. The mass-production of these boards is not cost-effective, given the great number of installation possibilities which are unlikely to fall within a limited number of models. In the past the board (defined a gswitchgear and controlgear assemblyh)...

The standard EN 60439-1 applies to low-voltage switchgear and controlgear assem-blies The minimum IP degree of protection is regulated by the CEI 64-8 installation stan- dards (inclusion of the harmonisation documents of the CENELEC HD384 series andthe IEC 60364 publication) which, in part 7, cover a number of special environments:construction and demolition sites, structures designed for agricultural or livestock breeding use, restricted conductor areas, caravans and caravan sites, environments with a greater risk in case of fire, public performance and entertainment areas, pools and, in the...

The information given below is valid for conditions of application at environmental temperatures no greater than 40 C.The data provided in the table should be considered merely as a guide because the resistance of technopolymers that come upon contact with chemical agents depends uponthe concentration of the agent, the temperature at the time of contact, the mechanical stress involved and the duration of the contact.If the accessories and equipments are to be used in the presence of acids, bases, solvents or high concentration oils, contact our Technical Service.Department > selection guide Table...

selection guide The electric systems which have come into existence since 1-7-2003 in work areas at risk of explosion due to the presence of gas, fumes, smoke or dangerous powders (exclud-ing mines) must comply with European Directive 99/92/EC (a.k.a.ATEX 137).This is the so called socialԔpart of the ATEX Directive > 1) , adopted within the general directive89/391/EC on the subject of safety at work, implemented in Italy as the well know Law Decree n.626/94 which merged with Law Decree n.233/03 under Title VIII-bis.According to this directive (art.8) employers must, among other things, develop...

This chapter explains the technical characteristics of the PLUSO series plugs andsocket-outlets for industrial purposes. The range of products covers a wide number of different installation requirements. The plugs and socket-outlets are suitable for fixed or mobile installations.The fixed plugs and socket-outlets may be wall or flush-mounted. Thanks to the wide range of the ILME enclosures of the FM, FC and BK series (types BC...) the flush-mounting plugs and socket-outlets can be assembled rapidly in a group configuration. These construction features enable ILME plugs and socket-outlets to be...

Composition of the part No.:e.g. PEW 125 12 3 PP > (low voltage)article series rated current in amperes earthing contact position in hours number of poles + earth design of plug or socket PE (IP44) and PEW (IP67) socket-outlets and couplerslow voltage over 50V up to 690V > wall-mounting socket-outletsstraight flush-mountingsocket-outletsinclined flush-mountingsocket-outletscouplers overview