ø22mm LED Pilot Light Indicators - AP22M Series Sunlight-viewable – Ultra-bright LED Indicators! Outstanding visibility, even in direct sunlight. High visibility from all directions Unique optical design Brightness Actual Size Twice as bright as standard pilot lights when viewed from the front, and up to 100 times brighter than standard pilot lights when viewed from side angles.

ø22mm Ultra-bright LED Pilot Lights - AP22M Series Key Features • Viewable in direct sunlight. Visible from all directions. The use of an ultra-bright LED that is not susceptible to external scattered light ensures high visibility and provides for more accurate recognition. Integrated terminal cover is IP20 (finger protection), preventing electrical shocks. UL and c-UL listed, EN standard compliant. Colored and clear lenses are offered. Specifications Operating Temperature Storage Temperature Operating Humidity Insulation Resistance Over Voltage Category Impulse Dielectric Strength Pollution...

Part Numbers Pilot Lights Appearance Rated Voltage Part Number Lamp Color In place of j insert LED color code: R (red), G (green), Y (yellow), A (amber), S (blue), and PW (white). White (PW) only available as colored lens. In place of k insert voltage code. For 12V DC use (3), for 24V AC/DC use (4), for 120V AC use (H). LED cannot be removed or replaced. Accessories & Replacement Parts Appearance Part Number Notes Used for mounting unit into a panel. Locking Ring Wrench Metal (brass) Nitrile rubber Dimension: ø29.8mm H14.5mm In place of j insert color code: R (red), G (geen), Y (yellow), A (amber),...

Safety Instructions T urn off the power before installation, removal, wiring, maintenance and inspection. Failure to turn off power may cause an electrical shock or fire hazard. When wiring, use proper size wires (AWG16 - AWG14) to meet voltage and current requirements. Tighten the terminal screws to the recommended tightening torque (1.0N•m). Operating with loose terminal screws may cause overheating and fire. Installation Instructions Panel Mounting Mounting Notes Remove the locking ring and check if the rubber gasket is properly aligned. Then insert the AP22M unit, align the "TOP" marking...