ID-471A
1Pages

An essential safety device for screening personnel entering areas where electrostatic discharges must be avoided. ID-471A Conduction to Ground Monitor The ID-471A Conduction to Ground Monitor is a control and display unit which is usually mounted on a wall at about shoulder height. This unit is connected by cable to a stainless steel plate on the ground just in front of the wall-mounted unit. By standing on the metal plate and holding the test handle on the wall unit the monitor circuit is activated and the electrical resistance is measured between the hand and the floor plate. In a number of industrial operations it is essential for personnel to be effectively bonded to ground at all times to prevent electrostatic spark discharges damaging sensitive electronic components or circuits, or causing ignition of flammable vapours or materials. Bonding to earth may be conveniently achieved via conductive footwear, but it is necessary to know if this bonding remains effective in practice. The ID-471A Conduction to Ground Monitor provides a simple to use and robust unit for checking the effective resistance between an operator and ground. The unit can be mounted at the point where personnel enter a hazardous area from a safe area, and may be used to prevent entry of staff with inadequately conductive footwear. SPECIFICATIONS & FEATURES Power Supply: Test Voltage: Critical resistance value: 471A/BS : 100MΩ Internally pre-set 471A/EN : 1000MΩ Internally pre-set External connections: An earth wire connection to stainless steel ground plate, and mains connection (footplate not included, but can be ordered separately). Self-Test & Maintenance: The ID-471 is equipped with a simple to use switch mounted on the side of the unit to test operation, thus minimising the time for regular maintenance checks. IDB Systems operate a calibration and maintenance support service details of which can be tailored to meet individual customer preferences. There are two versions of the ID-471A available, the ID-471A/BS and the ID-471A/EN. The ID-471A/BS model provides a simple Green PASS lamp if the resistance is below the value of 100MΩ which is pre-set within the instrument. The red FAIL lamp is illuminated if the resistance is above the 100MΩ. The ID-471A/EN model provides a simple Green PASS lamp if the resistance is below the value of 1000MΩ which is pre-set within the instrument. The red FAIL lamp is illuminated if the resistance is above the 1000MΩ. Please email support@idbsystems.co.uk for further details. Our engineering consultants would be pleased to discuss your requirements with you, and we invite you to contact our team at info@idbsystems.co.uk, alternatively you can call us on +44 (0) 1492 864 126. IDB Systems Limited is registered in England and Wales under 7324859 and the registered office is 10 Mostyn Street, Llandudno, LL30 1PS, Conwy, North Wales. ©IDB Systems