iC-DX / iC-DXC Digital Sensor Output Drivers The iC-DX / iC-DXC are monolithic switches for ohmic, inductive and capacitive loads. The supply voltage VB of the devices can range from 8 to 30 V and has integrated reverse polarity protection. The operational output source/sink-current is up to 150 mA for the iC-DX and up to 200 mA for the iC-DXC with maximum saturation voltages of 2 V. Their short circuit currents are limited to 450 mA. With input OE on high level state, the output works as a push-pull driver controlled by input IN. If IN is set either to high or low level, the output acts as a high-side (PNP) or low-side (NPN) driver which is activated by a high logic level on input OE. Output transitions are slew-rate limited to minimize interference (on lines). The devices are short circuit protected by shutting down with excessive temperature. A regulated 5 V power supply is available at pin VOUT to supply external circuitry with up to 10 mA. The iC-DXC additional features a feedback path of the state of output pin OUT. Forcing OUT externally from its current state is signalled at pin MON. This can be used to implement an IO-Link Wake-Up detection. Configurable high-side, low-side and push-pull operation 150 mA (iC-DX) and 200 mA (iC-DXC) output current IO-Link compliant (iC-DXC) Reverse polarity protection 5 µs input filter for spike supression Current limited output (< 450 mA) Wide supply voltage range from 8 to 30 V Driver shutdown with overtemperature Integrated free-wheeling diode for inductive loads Sensor supply voltage output of 5 V (10 mA) Digital sensors Light barriers Proximity switches DIGITAL INPUT Am Kuemmerling 18 • D -55294 Bodenheim, Germany Phone: +49 (6135) 9292-300 • Fax: +49 (6135) 9292-192 • http://www.ichaus.com

iC-DX / iC-DXC Digital Sensor Output Drivers Applications Examples Highside switch Supply Voltage Output Short-Circuit Duration Operating Temperature Range Saturation Voltage low/high (@ 100 mA) Saturation Voltage low/high (@ 150 mA) Saturation Voltage low/high (@ 200 mA) Short-Circuit Current low/high Slew Rate VB = 30 V, CL = 2.2 nF Lowside switch Thermal Shutdown Power-On Threshold Thermal Shutdown Temperature Regulator Output VOUT Output Voltage, VB = 9..30 V, I(VOUT) = 0..10 mA Short-Circuit Current, VOUT to GND Required Pulse Width at IN, OE for switching Spurious Pulse Width at IN, OE...