Catalog excerpts
-2- The following attention notices are used to notify andadvise the user of this product of procedures that may be dangerous to the user or result in damage to the product. Notes are used to notify of installation, operation, ormaintenance information that is important but not safety related.Caution is used to indicate the presence of a haz-ard, which will or can cause minor injury or property damage if the notice is ignored.Warning denotes that a potential hazard exists andindicates procedures that must be followed exactly to either eliminate or reduce the hazard, and to avoid serious...
Open the catalog to page 2
STRAINER See Figure 1 for recommended plumbing installation. Astrainer should be installed on the inlet side of the pump. INLET LINE Check the strainer periodically to ensure that it isnot clogged with debris.DISCHARGE HOSE AND FITTINGS Use a 3/4'' 2-braid suction hose or 3/4'' pipe to prevent collapsing. Avoid all unnecessary bends, elbows, or kinks in the inlet line. The less restrictions in the inlet line, the better the pump will perform. Avoid loops in the inlet line. Loops in the inlet line will permit air to be trapped in the line, preventing the pump from priming. Make sure all...
Open the catalog to page 3
Liquid fertilizers also have a tendency to causegumming if left in the pump. Thoroughly flush the pump after each use as described in Care of the Pump. > Popular uses for the 4101N-AE2H include starter fertil-izer application for row crop planting. Starter fertilizer is heavier than water per gallon (approx. 1.40 specific Gravity) and is also more viscous. These two charac- teristics will affect the performance as compared to water like herbicide/pesticide applications. Refer to the Performance Chart on page 6 for examples of perform- ance using 10-34-0 fertilizer. > Before starting the...
Open the catalog to page 5
Hypro warrants to the original purchaser of its products (the PurchaserӔ) that such products will be free from defects in materialand workmanship under normal use for the period of one (1) year for all products except: oil crankcase plunger pumps will be free from defects in material and workmanship under normal use for the period of five (5) years, and accessories will be free from defects in material and workmanship under normal use for the period of ninety (90) days. In addition, Hypro warrants to thepurchaser all forged brass pump manifolds will be free from defects in material and...
Open the catalog to page 8All Hypro Pressure Cleaning catalogs and technical brochures
-
PRODUCT CATALOG236 Pages
-
Transfer Pumps7 Pages
-
Gear Driven3 Pages
-
Centrifugal Pumps41 Pages
-
9302 Series2 Pages
Archived catalogs
-
ULD Sales Sheet2 Pages
-
ESI Sales Sheet2 Pages
-
TwinCap Sales Sheet2 Pages
-
HP Stainless Steel Nozzles2 Pages
-
UAS Ceramic Nozzles2 Pages
-
9302 Series Sales Sheet2 Pages
-
Hydraulic Pump Selection Guide38 Pages
-
Foam Marker OIPM20 Pages
-
Cleanload OIPM12 Pages
-
Series 2100 Versa-Twin OIPM16 Pages
-
Hydraulic Pressure Washer OIPM20 Pages
-
PowerLine Plunger OIPM24 Pages
-
2535S OIPM12 Pages
-
Series 5200 Piston Pump OIPM8 Pages
-
Series 5300 OIPM20 Pages
-
DBS & DBA Diaphragm Pump OIPM20 Pages
