OD Ground Nibs (Wire Drawing die blanks)_HyperionMT
1 / 8Pages

TOOLMAKER SOLUTIONS Cemented carbide drawing nibs providing tight dimensional tolerance and perfect coaxiality and meeting point Materials & Technologies

HYPERION NIBS FOR WIRE DRAWING DIES Hyperion Materials & Technologies cemented carbide drawing nibs are known for their impeccable geometry and unique and consistent grade composition. We offer not only a huge range of standard dimensions but also a superior quality in special designs. With outer diameter as sintered or ground. All dimensions in mm unless otherwise noted.

WIRE DRAWING STANDARD CEMENTED CARBIDE GRADES Co (wt%) ORDERING INFORMATION When ordering, replace dots (...) in the ordering code with your required inner diameter found in the table. ORDERING EXAMPLES: Nib 16x13, 12°, 0d1 = 2.10 mm with outer diameter as sintered Ordering code: WDSNR 160210 12MH6F M in the code (WDSNR... 16MH6F) = "meeting point” = > l3 = 0 When ordering nibs with ground outer diameter, replace the R in the code with a G = WDSNG... Nib 25x20, 16°, 0d1 = 4.80 mm with outer diameter as sintered Ordering code: WDSNR 250480 16BH6N B in the code (WDSNR...16BH6N) = "bearing...

HYPERION NIBS FOR WIRE DRAWING DIES Hyperion Cemented Carbide Standard JIS Nibs Ordering Code / Grade All dimensions in mm unless otherwise noted.

Standard HYPERION stock To be continue on the next page

With outer diameter as sintered or ground. All dimensions in mm unless otherwise noted. Standard HYPERION stock

Hyperion Cemented Carbide Large Standard Nibs CARBIDE GRADE PROPERTIES Carbide Grade * Faces will not be ground. CASING CHAMFER All dimensions in mm unless otherwise noted.

Materials & Technologies www.HyperionMT.com TS-WD 1905-002 ENG A4 Copyright © Hyperion Materials & Technologies - All rights reserved