EXHAUST REPAIR PUTTY
1Pages

EXHAUST REPAIR PUTTY SPECIALLY FORMULATED TO FILL SMALL HOLES AND CRACKS IN EXHAUST SYSTEMS. PRODUCT SHEET Pack size – 250g tubs Hylomar Exhaust Repair Putty is a water based, heat curing product. It has been specifically designed for use in the repair of exhaust systems for automotive and other general applications. The exhaust putty formulation will withstand both pressure and temperatures typically found in vehicle exhaust systems. When heated the product cures to form a gas tight seal. Typical Applications: + Specifically formulated to fill small holes and cracks in exhaust systems thus delaying the need for replacement. FEATURES + Water based + Heat curing + Specifically designed for use in the assembly of exhaust systems for automotive and other general applications + Withstand high temperature and pressure INSTRUCTIONS FOR USE Ensure the surfaces to be joined are clean and free of loose rust, dirt and grease. Abrade the surface with medium emery paper or wire brush. Moisten the area with water and apply the putty with a knife. Force the putty into the repair to give added strength. Soften putty with water if necessary. Replace lid firmly after use. Run the engine at low speed until warm, this will ensure rapid hardening of the repair putty and will set to form a gas tight seal. CAUTION: Avoid running engines in confined spaces. TYPICAL PHYSICAL PROPERTIES Appearance Specific Gravity @ 20°C (68°F) (ASTM D4659) Service Temperature Hylomar Limited Hylo House, Cale Lane, Wigan, WN2 1JT, UK | Tel: +44 (0)1942 617000 | Fax: +44 (0)1942 617001 Hylomar GmbH Talstraße 106, 41516 Grevenbroich, Deutschland | Tel: +49 (0)2182 570 8971 | Fax: +49 (0) 2182 5708970 Hylomar LLC 158 J J Lane, Center Point, Texas 78010, USA | Tel: +1 830 634 2603 Viscous Dark Grey