Components for hydraulic systems of dumptrucks Components for hydraulic systems of dumptrucks

Product catalog summary

Overview: The document provides technical specifications and details for the hydraulic systems used in dump trucks, focusing on the 'T' series gear pumps, control valves, and high-pressure hoses.

Specifications:

'T' Series Gear Pumps: Manufactured according to ISO standards, these pumps are suitable for right, left, and bidirectional rotation. They are designed to handle low sensitivity to axial and radial loads, allowing for pulley or gear drive. The housing and covers are made of cast iron. Displacement ranges from 34 to 100 ccm, with maximum continuous pressure from 180 to 280 bar, and maximum rotational speed from 1800 to 2800 rpm.
Control Valves (MR100.T Series): These proportional pneumatic tipping valves are suitable for medium- and heavy-duty trucks. The MR100.T4 model is designed for multiloop hydraulic systems. Rated flow is 100 lpm, with a maximum flow of 150 lpm and pressure settings ranging from 10 to 200 bar.
High-Pressure Hoses: Made of 2-braided rubber, these hoses can withstand pressures up to 400 bar and have a working life of at least 350,000 cycles. They conform to DIN and SAE standards.

Procedures and Recommendations:

Ensure proper installation of gear pumps and control valves according to the specified pressure and flow rates.
Regular maintenance and inspection of hoses and fittings are recommended to ensure longevity and performance.

Standards and Quality: The quality management system conforms to ISO 9001:2008, certified by Bureau Veritas, France.

Contact Information: Hydrosila, Ukraine, Kirovograd. Phone: +38 0522 35-83-37; Email: [email protected]

Catalog excerpts

Components for hydraulic systems of dumptrucks

Open the catalog to page 1

'T' SERIES GEAR PUMPS 'T' series gear pumps are manufactured with installation dimensions according to ISO standard. May be of right, left and bidirectional rotation. The main characteristic of these pumps is low sensitivity to axial and radial loads which permits to drive the pump using a pulley or a drive gear (spur or helical) installed on the pump shaft. Housing and covers for series ‘T’ pumps are made of cast iron. The pumps are applied on dump trucks, truck mounted boom lifts.

Open the catalog to page 2

Components for hydraulic systems of dumptrucks Components for hydraulic systems of dumptrucks-4

Hydraulic cylinders are produced for rear tippers and three-way tippers both. Various types of mounting are available. Standart series High pressure hoses are produced of 2-braided rubber for the pressure up to 400 bar. Working life is not less than 350 thousand cycles. Hoses are produced according to standards DIN and SAE, with straight and angle fittings of DKM and DKO light and hard series with thread adjustments (metric and inch) and flange adjustments. Quality management system conforms to ISO 9001:2008 by Bureau veritas, France

Open the catalog to page 4