Digital Microwave Moisture Sensor for Bulk Solids and Liquids GRAIN : FEED : NUTS : GRANULES : LIQUIDS

Hydro-Mix XT Flush mount, digital microwave moisture sensor The Hydro-Mix XT has been designed to measure moisture in flowing bulk solids such as animal feed, grain, rice, pulses and also in liquids. The sensor can be easily installed in ducting, conveying and mixing systems in process control environments. Comprising a single, intelligent unit that contains all on-board functionality including signal processing, smoothing and averaging, the Hydro-Mix XT accurately measures the moisture content of material passing over the ceramic faceplate. Remote configuration, calibration, diagnostics and firmware...

Typical Installation into Mixers or Conveyors The Hydro-Mix XT can be mounted in many different locations where there is a continuous flow of material across the ceramic faceplate. These include drying, ducting, conveying and mixing systems. Installation into Ducting Hydronix has developed a ducting system for the HydroMix XT sensor. This makes it simple to install the sensor in exactly the right position to achieve the most precise moisture measurement results. Hydronix recommends that our system is used in all ducting applications as it will easily allow us to support the Hydro-Mix XT. The Hydronix...

Technical Information Construction Refresh Rate Body: 316 Stainless Steel. Pressure: 1 Bar Vacuum to 5 Bar pressure. Faceplate: Ceramic. Internal Seals: EPDM FDA Approved O-Rings. Fixing Plate O-Ring: EPDM FDA Approved Fixing The sensor is flush mounted with the internal wall of the installation using the included mounting assembly. Measurement Range Protection: Cable Gland IP68. Analogue Outputs Two configurable 4-20mA or 0-20mA current loop source available for moisture and temperature. May also be converted to 0-10V DC. Digital Inputs/Output Two configurable digital signals available for averaging...