UNIVERSAL CYLINDERS with spring reset, single-acting, pmax. 500 (400) bar Description: Important notice: The universal cylinder is suitable to process changing work pieces with variable sizes in one clamping fixture. They are equipped with support ring and plug-in disk. Thus the cylinder can be directly installed into the fixture body. The design makes it possible to adjust the built-in depth in 10 mm increments. The universal cylinder with piston Ø 50 mm has a G1/8 ventilation screw. The cylinder must be protected from ingress of any coolants or cutting fluids into the spring chamber. The arrangement of the cylinders must be realized in a way that the ingress of liquids through the sintered metal air filter is prevented. Alternatively, the protection can be done by appropriate protective measures. Seal kits including fasteners are available as spare parts. Internal thread for contact bolts Vent screw G1/8 (only for piston Ø 50 mm) Snap L-ring We also design and manufacture special designs The universal cylinder with piston Ø 10 mm will be supplied including the contact bolt. Contact bolts for other cylinder variations on data sheet 1000-1. Order number: 7004-036 (spare part) Housing: machining steel, burnished Sinter metal air filter Piston: hardened steel Any installation position possible Suitable for changing workpiece sizes Adjustable build-in depth Easy to replace Protecting metal wiper Technical data: d1 Piston Ø d2 Piston rod Ø Stroke ± 1 Clamping force at 100 bar Clamping force at pmax. Max. op. pressure pmax. Max. spring reset Oil capacity/10 mm Stroke aØ b c e f g h x thread depth k l ± 0,5 r A/F 1 A/F 2 Weight approx. Order numbers: Seal kit (spare part): 220-2 / 02-13 *Subject to change without notice, compare issue no. at www.hydrokomp.de. Application example: Cylinder fixture Spacer ring (not included in scope of supply) Hydraulische Komponenten GmbH Siemensstraße 16, 35325 Mücke (Germany) Phone: +49 6401 225999-0 Fax: +49 6401 225999-50 E-mail: [email protected] Internet: www.hydrokomp.de