SWING CLAMP CYLINDERS threaded body with overload protection, single-/double-acting, pmax. 500 bar Designs: Webcode: 024030 We also design and manufacture special designs Operating conditions: Swing clamp cylinders release the clamping point on the workpiece. With this, it is easy to change the workpiece. For any risk of exceeding the permitted volume flow a throttle check valve must be interposed into the oil supply line (see data sheet 700-15). Counter-hold the clamp arm when tightening or loosening the counter nut in order to prevent torque transfer to the piston rod and to avoid damage to the ball guide. This hydraulic swing clamp cylinder operates as single-acting or double-acting pull cylinder, whereas part of the stroke is used to rotate the piston. The model with 0° swing angle operates only vertical as pull cylinder. To guarantee a long lifetime the cylinders have an integrated metal wiper as standard. For oil supply, the cylinders are equipped with threaded port and manifold connection with O-ring for drilled channels. You can select between right or left turning models with various standardized swing angles. The integrated overload protection protects the swing mechanism from damage due blockage of the rotation or improper assembly of the clamp arm. Variations with 0°, 30°, 45°, 60° and 90° swing angles are available. The permitted operating pressure is depending from the clamp arm length. Except from standard clamp arms also special clamp arms can be assembled. The maximum operating pressure of 500 bar does not apply for each clamp arm length. For details about the permitted operating pressure, refer to page 4. The safety instructions for swing clamp cylinders in our catalogue or on our website and the current accident prevention regulations must be considered. Connections: G1/4 threaded port Manifold with O-ring Advantages: Protecting metal wiper Integrated overload protection Oil supply through drilled channels or threaded port connection Fixture can be easily loaded and unloaded Easy to assemble with self designed clamp arms Standard and special clamb arms available (see page 4) Various contact bolts available (see data sheet 1000-1) Application example: 0° only clamping 90° swing motion left turning (basic position) 90° swing motion right turning (basic position) Hydraulische Komponenten GmbH Siemensstraße 16, 35325 Mücke (Germany) Phone: +49 6401 225999-0 Fax: +49 6401 225999-50 E-mail: [email protected] Internet: www.hydrokomp.de 240-30 / 02-13 *Subject to change without notice, compare issue no. at www.hydrokomp.de.

Swing clamp cylinders with overload protection Design B accessory: clamp arm (see page 3) accessory: clamp arm (see page 3) Installation instructions: The swing clamp cylinders will be delivered ready for connection. If a modification of the threaded ports on manifold ports become necessary, proceed as follows: single-acting cylinders are equipped with a filter in port B (notice the safety instructions for swing clamp cylinders in our catalogue). Technical data: [mm] Piston Ø: [mm] Clamping stroke [mm] Swing stroke [mm] Total stroke Min. operating pressure [bar] [cm³/s] Max. volume flow Oil requirement/stroke...

Swing clamp cylinders with overload protection Clamp arms: For these swing clamp cylinders, standard clamp arms are available as accessories. All necessary information about this can be found on the data sheet «Swing Clamp Cylinders - Clamp Arms» in the catalogue or at www.hydrokomp.de. Compatible clamp arms: Dimensions for house production of clamp arms: Piston Ø Ø ds x y Ø z1 Taper ratio Special clamp arms are available on request. Attention: consider the interference contour for the housing. Effective clamping force FSp depending from operating pressure p: e Effective clamping force FSp [kN]...