pumps with Load Sensing control variable displacement piston pumps ► Able to rotate in either direction, simply by changing position of the indexing screw ! ► Stock optimisation: only one reference regardless of direction of rotation ! ► Pump supplied with its inlet fitting. Minimum size envelope High rotating speeds High output pressure Pump reference Maximum operating pressure Maximum peak Max. speed Max. speed Torque at pressure at full displa300 bar(2) in stand-by cement(3) (intermittent: 5%) (1) TXV pumps can be set for smaller maximum displacements (see page 41). (2) For a mechanical efficiency at 85%. (3) Higher speed - at full displacement - possible depending on flow required : please contact us. (4) Value of the overhang torque of the only pu

Drain G1/2" to be connected to the tank stand-by pressure setting M10x1.5-6H (2x) Depth 15 mm to attach support device Connection for pressure gauge G1/4" Connection for pressure gauge G1/4" ► How to change direction of rotation Figure 1 • Take off the 2 half-flanges  and the inlet fitting . Take care not to lose the seal from the inlet fitting. Remove the plug  and the setting screw . Do not turn the pump shaft when the setting screw is not in place. Put the setting screw . in the place where the plug  was, and put the plug  where the setting screw  was. Check the inlet fitting  seal...