*mydirectindustry

S10T

Product catalog summary

Overview: The S10T Hydraulic Submersible Vortex Flow Trash Pump is engineered to manage large solids and fibrous materials using a fully recessed vortex impeller. It is suitable for applications such as sludge lagoons, sewage digester tanks, and fish farms. The pump can achieve shut-off heads up to 100 feet and flow rates up to 5,000 gallons per minute (gpm).

Key Features:

Fully recessed vortex impeller capable of passing 8-inch semi-solids.
Variable speed hydraulic drive for a wide range of performance.
Oil-lubricated seals allowing dry operation.
High-efficiency balanced vane hydraulic motor.
Can be directly bolted into pipelines or used as a booster pump.
Safe hydraulic drive suitable for hazardous or impractical electric power environments.
Compatible with HT100 to HT150 power units or other hydraulic power sources with flows of 50-70 GPM.

Specifications:

Weight: 745 lbs (346 kg)
Height: 45 inches (114 cm)
Width: 42.5 inches (108 cm)
Discharge and Inlet: 10-inch 125# ASA Flange
Solids Handling: Up to 8-inch (20 cm) spherical semi-solids
Hose Ports: 1 1/4" or 1 1/2" NPT(F) or SAE
Materials: Ductile Iron pump body and impeller, ASTM A36 Steel wear ring and plate, 17-4 PH Stainless Steel shaft, Silicon Carbide shaft seal, Buna N elastomers
Hydraulic Oil: 214-320 s.s.u. @ 100°F (64°C)
Input Flow: Maximum 70 GPM (265 LPM)
Operating Pressure: Maximum 3000 PSI (204 Bar)
Power Source: Any open center hydraulic system

Catalog excerpts

10” HYDRAULIC SUBMERSIBLE VORTEX FLOW TRASH PUMP MODELS S10T 10” (25 cm) Discharge The S10T is designed to handle large solids and stringy material with its fully recessed Vortex impeller. Typical applications include sludge lagoons, sewage digester tanks and fish farms. Shut off heads to 100 feet with flows to 5,000 gpm. Fully Recessed Vortex Impeller (will pass 8" semi-solids) Variable Speed hydraulic drive provides a wide range of performance Oil Lubricated Seals (can run dry) High Efficiency Balanced Vane hydraulic motor Can be bolted directly into a pipeline or used as a booster pump Safe Hydraulic Drive can be used where electric power is hazardous or impractical Operates with our HT100 to HT150 power units or other hydraulic power sources capable of flows of 50 - 70 GPM Specifications are subject to change without notice 167 Stock Street, Nesquehoning, PA 18240 Phone: 570-645-3779 Fax: 570-645-4061 Website: www.hydra-tech.com E-Mail: htpu

Open the catalog to page 1

CAPACITY Curves are based on pumping water at 60°F. For performance curves other than shown above, consult factory. 167 Stock Street, Nesquehoning, PA 18240 Phone: 570-645-3779 Fax: 570-645-4061 Website: www.hydra-tech.com E-Mail: [email protected]

Open the catalog to page 2