HYDRA-TECH PUMPS 1 1/2” HYDRAULIC SUBMERSIBLE SLIM-LINE PUMP MODEL S1.5A 1 1/2” (3.8 cm) Discharge The S1.5A is designed to be used as a dewatering pump in areas where space is limited . Typical uses for this pump include manhole, vault, blasthole, mine and construction jobsite dewatering. Can be used for village water supplies in remote areas. Heads to 120 feet. FEATURES • Small Overall Size Allows Pump To Fit Through 6" Diameter Opening • Oil Lubricated Seals (can run dry) • Variable Speed hydraulic drive • Stainless Steel Impeller resists wear • Rubber Coated Suction Case resists abrasion • Safe Hydraulic Drive can be used where electric power is hazardous or impractical • Dependable gear type hydraulic motor • Operates with our HT6 to HT13 power units or other hydraulic power sources capable of flows of 3-7 GPM • Stainless Steel model available OPERATING PRESSURE:. Max 2000 PSI (136 Bar) POWER SOURCE:.. Any Open Center Hydraulic System Specifications are subject to change without notice 167 Stock Street, Nesquehoning, PA 18240 Phone: 570-645-3779 Fax: 570-645-4061 Website: www.hydra-tech.com E-Mail: [email protected]

3/8" NPT(F) Hydraulic Connections 5 5/16"- i*:* :*»*i*i*»*i Curves are based on pumping water at 60 F. For performance curves other than shown above, consult factory. 167 Stock Street, Nesquehoning, PA 18240 Phone: 570-645-3779 Fax: 570-645-4061 Website: www.hydra-tech.com E-Mail: [email protected]