60mm (T) Geared Synchronous Motor
6Pages

SYNCHRONOUS MOTOR FAMILY Series 60mm (T) Geared Synchronous Motor Torque Range: Output Speed: Poles: Insulation Class: Up to 250 oz-in [1765 mN-m] .25 to 300 RPM T Series 24 poles; TA Series 20 poles Class A (105°C) 4 leads 22AWG (approx. 12 inches [304.8 Lead Wire: mm]) Operation Ambient Temp: -10°C to +40°C (approx.) Zinc Die Cast - AGMA 7 Standard with Gear Unit: hardened steel gears Shaft Bearing: Sleeve Bearing E53578(N), Component-Impedance Protected Motors, Recognition: 115Vac Standard Rotor Card No. 42576, Motors and Generators, Certification: 115 Vac, 60 Hz, Standard Rotor, 7 watts max. Note: Typical data subject to change without notification Reversible, permanent magnet synchronous series T geared motors are available in a wide range of speeds. The gear trains are the most rugged with a maximum recommended loading of 250 oz-in [1765.4 mN-m] at 1 RPM. All gears are hobbed to AGMA 7 quality. Pinions are extruded from a special steel with a modified long addendum tooth form to provide higher strength. Pinions are held to the same AGMA 7 quality level as the gears. Both pinion and gear teeth are case hardened for wear resistance and rotate upon hardened and ground steel studs. Standard motors are 115V, 60Hz but other voltages may be specified. Sleeve bearings are standard. Capacitors are required for operation and must be used in the circuit even if the motor is used in a unidirectional mode. Hurst 1551 East Broadway Street Princeton, IN 47670 MOTOR SPECIFICATION SHEET

Rated Rated Output Part Reduction Torque Torque Speed Number (oz-in) (mN-m) (RPM) Input Voltage Voltage Capacitor Capacitor Weight Weight Power (VAC) (VAC) Value not (oz) (g) (watts) 50HZ 60HZ (mfd) supplied Hurst 1551 East Broadway Street Princeton, IN 47670 MOTOR SPECIFICATION SHEET

Rated Rated Output Part Reduction Torque Torque Speed Number (oz-in) (mN-m) (RPM) Input Power (watts) Voltage Voltage Capacitor Capacitor Weight Weight (VAC) (VAC) Value not (oz) (g) 50HZ 60HZ (mfd) supplied Hurst 1551 East Broadway Street Princeton, IN 47670 MOTOR SPECIFICATION SHEET

Rated Part Reduction Torque Number (oz-in) Rated Output Torque Speed (mN-m) (RPM) Input Voltage Voltage Capacitor Capacitor Weight Weight Power (VAC) (VAC) Value not (oz) (g) (watts) 50HZ 60HZ (mfd) supplied Hurst 1551 East Broadway Street Princeton, IN 47670 MOTOR SPECIFICATION SHEET

Hurst 1551 East Broadway Street Princeton, IN 47670 MOTOR SPECIFICATION SHEET

Wiring Diagram Optional Wiring Diagram with Switch Capacitors are non-polarized and must always be connected between the red and black leads. Always connect the (2) coil blue leads together. Connect the power supply to the blue leads and red lead to produce clockwise (CW) rotation viewing shaft end. Connect the power supply to the blue leads and black lead to produce counter-clockwise (CCW) rotation viewing shaft end. SINGLE-POLE DOUBLE THROW (SPDT) SWITCH Capacitors are non-polarized and must always be connected between the red and black leads. Always connect the (2) coil blue leads...