49mm (A, AB) Direct Drive Synchronous Motor
4Pages

SYNCHRONOUS MOTOR FAMILY Series 49mm (A, AB) Direct Drive Synchronous Motor Output Speed: Insulation Class: Lead Wire: Operation Ambient Temp: Shaft Bearing: 300 to 600 RPM Class A (105°C) 4 leads 22AWG (approx. 9 inches [228.6 mm]) -10°C to +40°C (approx.) Sleeve Bearing E37163, Component Time Indicating and Recording Appliances, Recognition: 115Vac 60 Hz Standard Rotor Card No. 42576, Motors and Generators, Certification: 115 Vac, 60 Hz, Standard Rotor, 3 watts max. Capacitor is required for operation. Capacitor supplied with 115 Vac motors. Note: Typical data subject to change without notification Series A and AB reversible, permanent magnet direct drive 60Hz models have Standard motors are 115VAC for 60HZ operation. Other voltages and 50 Hz frequency may be specified. Rated torque with standard rotor for A and AB is 2.0oz-in [14.12 mN-m] and 2.3 oz-in [16.24 mN-m]; with Hi-Torque rotor is 2.7 oz-in [19.07 mN-m] and 3.75 oz-in [26.48 mN-m] respectively. These motors, among the most popular in the HURST® line, are designed for heavy duty and are widely used in computer peripheral equipment, chart drives, medical instruments and a great variety of industrial applications. Notes: • Motors Listed below are 115V,60 Hz models. • Capacitors are required for operation and must be used in the circuit even if the motor is used in a unidirectional mode synchronous speeds of 300 RPM and 600 RPM respectively. Hurst 1551 East Broadway Street Princeton, IN 47670 MOTOR SPECIFICATION SHEET

Part Number Rated Torque (oz-in) Full Load Capacitor Temp. Value (mfd) Rise °C Input Power (watts) Maximum Capacitor HiGear not Torque Train supplied Rotor Loaidng Hurst 1551 East Broadway Street Princeton, IN 47670 MOTOR SPECIFICATION SHEET

Wiring Diagram Optional Wiring Diagram with Switch Capacitors are non-polarized and must always be connected between the red and black leads. Always connect the (2) coil blue leads together. Connect the power supply to the blue leads and red lead to produce clockwise (CW) rotation viewing shaft end. Connect the power supply to the blue leads and black lead to produce counter-clockwise (CCW) rotation viewing shaft end. SINGLE-POLE DOUBLE THROW (SPDT) SWITCH Capacitors are non-polarized and must always be connected between the red and black leads. Always connect the (2) coil blue leads...