Catalog excerpts
SYNCHRONOUS MOTOR FAMILY Series 35mm (LYD35) Direct Drive Synchronous Motor Frame Size: Output Speed: Standard Voltages: Insulation Class: Lead Wire: Operation Ambient Temp: Shaft Bearings: 35mm 250/300 RPM (50/60 Hz respectively) 115 Vac & 24 Vac 50/60 Hz Class A (105°C) 4 leads 28AWG (approx. 9 inches [228.6 mm]) -10°C to +40°C (approx.) Sleeve bearings E53578(N), Component-Impedance Protected Motors Recognition: Capacitor is required for operation. Capacitor supplied with 115 Vac motors. Note: Typical data subject to change without notification Part Number Nominal Minimum Minimum Output Input Winding Capacitor Capacitor Length Inductance Weight Weight Length Voltage Torque Torque Speed Power Resistance Value not (L, (VAC) (mH/phase) (oz) (g) (L, in) (oz-in) (mN-m) (RPM) (watts) (ohms) (mFd) supplied mm) 50/60 Hz Hurst 1551 East Broadway Street Princeton, IN 47670 MOTOR SPECIFICATION SHEET
Open the catalog to page 1
Hurst 1551 East Broadway Street Princeton, IN 47670 MOTOR SPECIFICATION SHEET
Open the catalog to page 2
Wiring Diagram Optional Wiring Diagram with Switch Capacitors are non-polarized and must always be connected between the red and black leads. Always connect the (2) coil blue leads together. Connect the power supply to the blue leads and red lead to produce clockwise (CW) rotation viewing shaft end. Connect the power supply to the blue leads and black lead to produce counter-clockwise (CCW) rotation viewing shaft end. SINGLE-POLE DOUBLE THROW (SPDT) SWITCH Capacitors are non-polarized and must always be connected between the red and black leads. Always connect the (2) coil blue leads...
Open the catalog to page 3All Hurst catalogs and technical brochures
-
BRUSHLESS DC MOTOR FAMILY7 Pages
-
HURST® 2008 Catalog55 Pages
