*mydirectindustry

Catalogs
Hughes Safety Showers
EXP-AH-2GS Datasheet

EXP-AH-2GS Datasheet

Product catalog summary

Product Overview: The trace tape heated wall mounted safety shower is designed for environments with low ambient temperatures that may cause water in the pipes to freeze. It is suitable for both hazardous and non-hazardous environments and conforms to EN and ANSI standards. The shower provides a continuous water flow of 76 liters per minute at temperatures as low as -20°C.

Specifications:

Materials of Construction: Stainless steel pipework and fittings, injection moulded nylon 6 shower nozzle, polyurethane foam insulation with a medium density polyethylene outer casing.
Electrical Equipment: Suitable for ATEX Zone 1 & 2, Gas groups IIA & IIB, Temp Class T3 (IIC available).
Electrical Supply: 240V, single phase, 50/60Hz (110V available).
Heating Type: Trace tape heated and insulated with a heating load of 12 watts.
Water Inlet: 1 1/4” female BSP.
Operating Pressure: 2 to 6 BAR G / 29 to 87 PSI, with optional pressure reducing valve for higher pressures.
Minimum Flow Rates: 76 L per minute / 20 US gal per minute.
Ambient Operating Temperature: Minimum -25°C / -13°F, Maximum 35°C / 95°F.

Operation: The shower is operated by a pull handle.

Dimensions & Weight:

Dimensions: 260mm (10.2in) x 900mm (35.4in) x 689mm (27.1in).
Weight: 12kg (26lb).

Installation Notes: The electrical supply should be 240V/1PH/50 or 60Hz. The shower is suitable for use in Zone 1 & 2 areas, Gas groups IIA, IIB.

Catalog excerpts

Trace tape heating and pre-insulation make this emergency safety shower suitable for environments where there is a possibility of low ambient temperatures causing the water within the pipework to freeze. This wall mounted model is a great solution in locations with limited floor space. When connected to a mains supply, the shower delivers 76 litres per minute continuous water flow in temperatures down to -20C. Suitable for both hazardous and non-hazardous environments. Conforms to EN and ANSI standards. Justrite Safety Group

Open the catalog to page 1

General Arrangement Drawing Trace tape heated wall mounted safety shower EXP-AH-2GS 1 WALL MOUNTED JUNCTION BOX FOR TRACE TAPE HEATING 4x 15 HOLES FOR M12 FIXING BOLTS (NOT SUPPLIED) 1-1/4 INCH BSP(F) TOP/REAR WATER INLET SHOWER NOZZLE INSULATED POLYETHYLENE JACKET WITH TRACE TAPE HEATING INSIDE FIXING DETAIL VIEW SHOWER BALL VALVE SHOWER HAND CONTROL HEIGHT TO SHOWER NOZZLE 2083mm TO 2438mm (82" TO 96") FROM STANDING SURFACE D NAME DRAWN: Whitefield Road, Bredbury Stockport, Cheshire, SK6 2SS T: +44(0)161-430-6618 E: [email protected] DIMENSIONS ARE IN MILLIMETRES UNLESS SPECIFIED OTHERWISE...

Open the catalog to page 2

EXP-AH-2GS Datasheet

EXP-AH-2GS Datasheet

Catalog excerpts

All Hughes Safety Showers catalogs and technical brochures