Catalog excerpts
TECHNICAL SHEET CUTTING NIPPER PRODUCER: „HUBIX" CHARACTERISTICS Insulated tool made of CrV. One layer of insulation, red, made of polyamide with the 30% addition fibreglass. . Tool has a guard that the hand is prevented from slipping towards the uncovered conductive parts. Tool is controlled and tested (10kV/10s) in accordance with EN 60900:2004 Length: 160mm Weight: 220g APPLICATION Live working up to 1000V a.c. and 1500V d.c. Tool is used to cut wires (Al, Cu, Fe - cutting capacity to 10mm2) on overhead lines and connecting boxes. STORAGE AND MAINTENANCE Insulated or insulating hand tools should be properly stored to minimize the risk of damage to the insulation due to storage or transportation. These tools should be stored generally separated from other tools to avoid mechanical damage or confusion. Tool should be prevented from excessive heat and sun light. Use a dry tissue to clean. When tool becomes strong soiled use suitable solvent to clean. CHECK AND PERIODIC INSPECTION Before use, each hand tool should be visually inspected by the user. An annual visual examination by a suitably trained person is recommended to determine the suitability of the tool for further service. The visual check shall be considered successful if: o The tool (in particular the insulation) is free from external defect, o The marking is legible and complete.
Open the catalog to page 1Don’t use damaged, worn-out (cracks or deep scratches on insulation) or dirty tools in live working. Tool which becomes wet must be dried before use ATTENTION! In case of doubt after visual examination, the routine dielectric test should be preformed. FREQUENCY TESTS For check and periodic inspection to be carried out in according to table. PERIODIC INSPECITON PERIODIC INSPECION CARD supervisor result
Open the catalog to page 2All Hubix Sp. z o.o. catalogs and technical brochures
-
Live Working
104 Pages
-
LIVE WORKING SAFETY REINVENTED
40 Pages
-
BIRD PROTECTION SYSTEM
8 Pages
-
SAFETY TOOLS FOR E-MOBILITY
36 Pages
Archived catalogs
-
Dry cleaning set
28 Pages
-
Dry cleaning set 36kV
34 Pages
-
Equipment 1kV
102 Pages
-
Tools 1kV
128 Pages
-
General Catalogue
234 Pages
-
HT
2 Pages
-
HN10N
2 Pages
-
HN8N
2 Pages
-
HSZ
2 Pages
-
Hack-saw
2 Pages
-
INSULATED TORQUE WRENCH ½?
2 Pages
-
RATCHET CABLE CUTTER
2 Pages
-
11923678
2 Pages
-
11923671
2 Pages
-
HS-7
2 Pages
-
HS1
2 Pages
-
11923694
2 Pages
-
11923683
2 Pages
-
11923670
2 Pages
-
11923586
2 Pages
-
11923708/
2 Pages
-
11923687
2 Pages
-
11923680
2 Pages
-
11923923
1 Pages
-
11923948
1 Pages
-
11923949
1 Pages
-
11923922
1 Pages
-
11923951
1 Pages
-
Equipment
1 Pages
-
Hand
1 Pages
-
Hand tools
1 Pages
-
SECRA catalogue
4 Pages